Hamilton-T1 Oxygen Cells Replacement - iFixit 修理ガイド

はじめに

This guide is created for the replacement of oxygen cells in the Hamilton-T1 Ventilator. Replacing the oxygen cells is a crucial step in maintaining and keeping a working ventilator.

NOTE:

Replace the oxygen cell with genuine Hamilton Medical parts only; otherwise, oxygen measurement will not function. To prevent a permanent alarm make sure to use special Hamilton Medical oxygen cells only.
To prevent leakage within the ventilator, make sure an oxygen cell is installed at all times, even if you use an external monitor or disable oxygen monitoring.

必要な工具と部品

手順1 Oxygen Cells

Hamilton-T1 Oxygen Cells Replacement, Oxygen Cells: 手順 1、 1の画像 1

Flip device around until the back panel is exposed.

手順2

Hamilton-T1 Oxygen Cells Replacement: 手順 2、 1の画像 1

Remove the screw in the bottom center of the panel, and then take the panel off.

手順3

Hamilton-T1 Oxygen Cells Replacement: 手順 3、 1の画像 1

Disconnect the oxygen cell by removing the tube.
Then twist the cell counter-clockwise and pull to remove the oxygen cell.
Install the new oxygen cell and put the back cover on.

手順4

After the cell is installed. Run the oxygen cell calibration.
Oxygen calibration guide can be found in 3-11 of the Hamilton-T1 operations manual.

終わりに

After the installation and calibration of the oxygen cell. The Hamilton-T1 Ventilator is ready to operate.

添付文書

HAMILTON-T1 Operator's Manual SW2.1x EN

PDF - 4.17 mb

表示する

作成者

1人の作成者と共同作成されました。

Tyler

メンバー登録日: 04/09/20

114 ポイント

1ガイドが承認済み

+1 以上のバッジ

チーム

Cal Poly, Team S11-G24, Paton Spring 2020 Cal Poly, Team S11-G24, Paton Spring 2020人のメンバー

CPSU-PATON-S20S11G24

3 メンバー

3のガイドは作成済み

0 件のコメント

統計データ:

過去 24時間: 5

過去 7 日: 14

過去 30 日: 58

今までの合計 2,221