はじめに

This guide will explain how to install / remove the camera flash on the HTC Wizard 200.

Remove the back case with your fingernail to expose the battery. (Not shown in picture)
  • Remove the back case with your fingernail to expose the battery. (Not shown in picture)

  • Pull the black tab to remove the battery.

コメントを追加する

Use a spudger to begin removal of the camera cover by inserting the flat end into the two notches and gently pry them up one at a time.
  • Use a spudger to begin removal of the camera cover by inserting the flat end into the two notches and gently pry them up one at a time.

コメントを追加する

  • Work the spudger around the edge of the camera cover to release the clips.

コメントを追加する

  • Use a T5 Torx screwdriver to remove four 6mm screws that secure the back panel to the main body.

  • There is a screw under the "void" sticker.

コメントを追加する

  • Device rotated 180 degrees.

  • Insert the flat end of a spudger into the crack between the front and rear cover.

  • Once you have enough of a gap to fit a plastic opening tool into it, use the opening tool to release the clips.

コメントを追加する

  • Use the plastic opening tool to continue releasing the clips until you have worked your way around the edge.

コメントを追加する

  • Pull off the back case panel.

コメントを追加する

  • Use the spudger to pry out the camera flash module.

コメントを追加する

まとめ

To reassemble your device, follow these instructions in reverse order.

Kyle Champ

メンバー登録日: 2011年10月03日

204 ポイント

12のガイドは作成済み

チーム

Cal Poly, Team 20-27, Maness Fall 2011 Cal Poly, Team 20-27, Maness Fall 2011人のメンバー

CPSU-MANESS-F11S20G27

4 メンバー

12のガイドは作成済み

コメントを追加する

統計データを表示:

過去 24時間: 0

過去 7 日: 0

過去 30 日: 2

今までの合計 586