はじめに

Remove 4 Torx screws and 2 #00 Philps

First remove the back cover of your phone to expose the battery.
  • First remove the back cover of your phone to expose the battery.

コメントを追加する

Turn the phone over and remove the battery by using your thumb to push forward on the battery and then lift it.
  • Turn the phone over and remove the battery by using your thumb to push forward on the battery and then lift it.

コメントを追加する

Take the battery out When reassembling, make sure that the battery contacts match up.
  • Take the battery out

  • When reassembling, make sure that the battery contacts match up.

コメントを追加する

Remove the four 4.9mm T6 Torx screws that secure the back panel to the rest of the phone Remove the four 4.9mm T6 Torx screws that secure the back panel to the rest of the phone
  • Remove the four 4.9mm T6 Torx screws that secure the back panel to the rest of the phone

コメントを追加する

Remove the two 4.3mm #00 Phillips screws that secure the back panel to the rest of the phone
  • Remove the two 4.3mm #00 Phillips screws that secure the back panel to the rest of the phone

コメントを追加する

Use the plastic opening tool to pry the clips off Insert the plastic opening tool along the seams at different points to it pry up This may require a bit of force. The USB port cover may fall off in this step.
  • Use the plastic opening tool to pry the clips off

  • Insert the plastic opening tool along the seams at different points to it pry up

  • This may require a bit of force. The USB port cover may fall off in this step.

コメントを追加する

まとめ

To reassemble your device, follow these instructions in reverse order.

Andrew Van Meter

メンバー登録日: 2011年10月06日

24 ポイント

3のガイドは作成済み

チーム

Cal Poly, Team 20-29, Maness Fall 2011 Cal Poly, Team 20-29, Maness Fall 2011人のメンバー

CPSU-MANESS-F11S20G29

4 メンバー

9のガイドは作成済み

コメントを追加する

統計データを表示:

過去 24時間: 0

過去 7 日: 0

過去 30 日: 0

今までの合計 706