メインコンテンツにスキップ

HP iPAQ h4155 Backup Battery Replacement

必要な工具と部品

  1. HP iPAQ h4155 Backup Battery Replacement, Battery: 手順 1、 1の画像 1
    • While sliding the silver release tab up, simultaneously lift the cover up from the left side.

  2. HP iPAQ h4155 Backup Battery Replacement: 手順 2、 1の画像 1
    • Push the tab left to right to remove the cover.

  3. HP iPAQ h4155 Backup Battery Replacement: 手順 3、 1の画像 1
    • Now, lift the battery up and away from the device to remove it.

  4. HP iPAQ h4155 Backup Battery Replacement, Back Case: 手順 4、 1の画像 1
    • Remove the four silver screws using the T5 Torx Screwdriver (T5 x .25 in).

  5. HP iPAQ h4155 Backup Battery Replacement: 手順 5、 1の画像 1
    • Remove the single black screw that is located beneath the HP sticker with the T5 Torx Screwdriver.

  6. HP iPAQ h4155 Backup Battery Replacement: 手順 6、 2の画像 1 HP iPAQ h4155 Backup Battery Replacement: 手順 6、 2の画像 2
    • Next, use your plastic removal tool to separate the gray back from the black center piece.

    • For better results, start the separation at the corner piece.

  7. HP iPAQ h4155 Backup Battery Replacement: 手順 7、 1の画像 1
    • Remove the back case.

  8. HP iPAQ h4155 Backup Battery Replacement, Face Plate: 手順 8、 1の画像 1
    • Now that the back cover is removed, use the #00 Philips x .17 screwdriver to remove the small screw to the left of the SD card slot.

  9. HP iPAQ h4155 Backup Battery Replacement: 手順 9、 2の画像 1 HP iPAQ h4155 Backup Battery Replacement: 手順 9、 2の画像 2
    • Next, unlock and remove the ribbon cable.

    • Using metal tweezers, carefully pull back on both sides of the brown bar unlocking the cable and slipping it out of the connector.

    • The bar, the connector, and the cable are fragile components that are easily broken.

  10. HP iPAQ h4155 Backup Battery Replacement: 手順 10、 2の画像 1 HP iPAQ h4155 Backup Battery Replacement: 手順 10、 2の画像 2
    • Next, remove the wire from the bottom of the mother board.

    • The easiest method is to use metal tweezers and grip the plug closest to the connector.

    • Make sure all the connections are properly disconnected before separation from the motherboard.

  11. HP iPAQ h4155 Backup Battery Replacement: 手順 11、 1の画像 1
    • Next, use a plastic removal tool and separate the silver front case from the black frame.

  12. HP iPAQ h4155 Backup Battery Replacement, JoyPad buttons: 手順 12、 1の画像 1
    • Remove the 4 screws along the bottom of the faceplate

    • They are #00 Philips head screws

  13. HP iPAQ h4155 Backup Battery Replacement: 手順 13、 2の画像 1 HP iPAQ h4155 Backup Battery Replacement: 手順 13、 2の画像 2
    • Once removed you can easily separate the keys from the body.

  14. HP iPAQ h4155 Backup Battery Replacement, Backup Battery: 手順 14、 2の画像 1 HP iPAQ h4155 Backup Battery Replacement, Backup Battery: 手順 14、 2の画像 2
    • once the joypad key have been removed use the tweezers to carefully maneuver the wire out of its clip releasing the battery

終わりに

To reassemble your device, follow these instructions in reverse order.

4 の人々がこのガイドを完成させました。

作成者

4人の作成者と共同で作成されました。

John Pagliero

メンバー登録日: 01/27/11

942 ポイント

7のガイドは作成済み

2 件のコメント

This guide is AWESOME.. Thanks! I have an iPAQ 1945 h1900, but this guide was the exact same for my device. I got as far as the taking the battery out without removing the 5th screw beneath the "warranty void" sticker. My only issue--do you know where to get the replacement battery?

Drew Stafford - 返信

IMPORTANT. The back up battery does not show charge immediately ( i don't know why ) Id read something before. When in April 2023 i swapped the old B U Batt for a known good one from another ipaq. At the end of the job . The level of charge on the b.up was zero. I charged the main batt to 100% then removed the ipaq from the charger and left it for a couple of hours . When I next checked it there was 100% on both batts....

Ron - 返信

コメントを追加

統計データ:

過去 24時間: 3

過去 7 日: 4

過去 30 日: 22

今までの合計 3,497