HP Stream 11-y012nr WiFi Card Replacement

はじめに

Has your WiFi stopped working all together and no amount of troubleshooting, software changes, or driver installations has fixed the issue? It most likely at this point is a faulty hardware issue. In this guide we will show you how to replace the WiFi card altogether. Follow the guide carefully and slowly to be sure of no mistakes or errors to prevent further problems.

必要な工具と部品

手順1 WiFi Card

HP Stream 11-y012nr WiFi Card Replacement, WiFi Card: 手順 1、 3の画像 1

HP Stream 11-y012nr WiFi Card Replacement, WiFi Card: 手順 1、 3の画像 2

HP Stream 11-y012nr WiFi Card Replacement, WiFi Card: 手順 1、 3の画像 3

Before disassembling the laptop, make sure to power off the device and unplug it from the charger.
Turn the laptop over to access lower case.
Using a metal spudger, remove the two horizontal screw covers.

編集

手順2

Remove the seven 5.6 mm Phillips #00 screws.

編集

手順3

HP Stream 11-y012nr WiFi Card Replacement: 手順 3、 3の画像 3

When using the metal spudger, be careful to not press into the components and circuits under the keyboard.
Turn the laptop upright and lift the screen.
Use metal spudger to carefully pry the plastic keyboard from the base of the laptop.
Work the spudger carefully and slowly around the cover to release the clips holding it together. Be sure to be patient since there are a lot of clips attaching the laptop base to the keyboard.
Gently lift up the keyboard.

編集

手順4

HP Stream 11-y012nr WiFi Card Replacement: 手順 4、 3の画像 3

この手順で使用する道具：

Tweezers

$4.99

購入する

The cover is attached by multiple cables. Be careful not to lift the cover too far so you do not damage these cables.
Using tweezers, unplug the three cables attached to the keyboard. To do so you will find where the wires end (the three red marks). The next step is to use tweezers or your fingers to pinch the plastic piece holding the wires, and gently pull the piece out. After that it should disconnect.
Remove the plastic keyboard cover.