修理を始めるには コミュニティ ストア

HP Spectre 13 4003dx x360 Battery Replacement

はじめに

This guide will give you step-by-step instructions on how to remove your battery. Make sure you have a clean, dry, uncluttered, and roomy work space that has good lighting before you start. Also, make sure that your battery actually needs to be replaced by consulting our troubleshooting guide.

必要な工具と部品

  1. HP Spectre 13 4003dx x360 Battery Replacement, Battery: 手順 1、 2の画像 1 HP Spectre 13 4003dx x360 Battery Replacement, Battery: 手順 1、 2の画像 2
    この手順で使用する道具：
    Magnetic Project Mat
    $19.95
    購入する

    • Before you begin, be sure to turn off your laptop and discharge the battery down to 25%.

    • Turn the computer upside down.

    • Use the T5 Torx Screwdriver to remove the eight 3.3 mm screws.

    • Make sure to use the magnetic project mat to help you keep track of the small screws.

    翻訳

  2. HP Spectre 13 4003dx x360 Battery Replacement: 手順 2、 2の画像 1 HP Spectre 13 4003dx x360 Battery Replacement: 手順 2、 2の画像 2

    • Use an opening tool to pry up and loosen the back case from the laptop.

    • If the back case doesn't loosen easily, there may be screws hidden underneath the rubber feet. Carefully pry a foot up and remove any hidden screws.

    • Remove the back case.

    翻訳

  4. HP Spectre 13 4003dx x360 Battery Replacement: 手順 3、 2の画像 1 HP Spectre 13 4003dx x360 Battery Replacement: 手順 3、 2の画像 2

    • Remove the four 2mm Phillips #00 screws securing the battery.

    • The screw locations are marked by small white arrows on the battery.

    翻訳

  5. HP Spectre 13 4003dx x360 Battery Replacement: 手順 4、 3の画像 1 HP Spectre 13 4003dx x360 Battery Replacement: 手順 4、 3の画像 2 HP Spectre 13 4003dx x360 Battery Replacement: 手順 4、 3の画像 3

    • Peel off the adhesive on the left side of the battery holding the speaker wire down.

    • Move the battery slightly to gain access to the battery plug, located on the left edge of the battery.

    • Carefully unplug the battery by pulling the connector towards the battery.

    • Pull parallel to the battery, not straight up.

    • Remove the battery.

    • It is normal for your battery to flex and bend a bit where the wider section meets the narrower section.

    翻訳
終わりに

To reassemble your device, follow these instructions in reverse order.

For optimal performance, after completing this guide, calibrate your newly installed battery.

Take your e-waste to an R2 or e-Stewards certified recycler.

Repair didn’t go as planned? Try some basic troubleshooting, or ask our Answers community for help.

7 の人々がこのガイドを完成させました。

作成者

5人の作成者と共同で作成されました。

Alie Antar

メンバー登録日: 01/29/18

661 ポイント

2のガイドは作成済み

バッジ: 12

+9 個以上のバッジ

チーム

USF Tampa, Team S5-G4, Passmore Spring 2018 USF Tampa, Team S5-G4, Passmore Spring 2018人のメンバー

USFT-PASSMORE-S18S5G4

3 メンバー

8のガイドは作成済み

5件のガイドコメント

I have five T4 screws that came out without issue and three that refuse to budge. Now I am trying to figure out how to remove those without damaging the laptop itself.

fxb - 返信

Thank you! iFixit repair kit made getting the screws out easy. Now have a renewed laptop ready with 6 plus hours of battery life.

Nicholas Steblay - 返信

Tutoriel parfait, excepté peut-être qu’un double-fil côté droit de la batterie doit être libéré avant de sortir la batterie.

Bravo et merci, ça m’a tout simplement permis de me dépanner seul.

FirstName LastName - 返信

The official HP Manual (http://h10032.www1.hp.com/ctg/Manual/c04...) mentions using Torx T5 to remove the bottom cover.

Gitesh Agarwal - 返信

Thanks! I will correct the step with the right screw size.

Arthur Shi -

コメントを追加

統計データ:

過去 24時間: 4

過去 7 日: 14

過去 30 日: 93

今までの合計 24,384