修理を始めるには コミュニティ ストア

HP ProBook 4520s Hard Drive Replacement

はじめに

If your HP ProBook 4520s shuts down without warning, you may have a hard drive error and need to replace the hard drive.

必要な工具と部品

  1. HP ProBook 4520s Hard Drive Replacement, Battery: 手順 1、 2の画像 1 HP ProBook 4520s Hard Drive Replacement, Battery: 手順 1、 2の画像 2

    • Flip the 4520s upside-down with the front toward you.

    • Push the two latches below the battery inwards at the same time.

    編集

  2. HP ProBook 4520s Hard Drive Replacement: 手順 2、 1の画像 1

    • Remove the battery by holding the latches and sliding the battery away from you.

    編集

  3. HP ProBook 4520s Hard Drive Replacement, Switch Cover: 手順 3、 2の画像 1 HP ProBook 4520s Hard Drive Replacement, Switch Cover: 手順 3、 2の画像 2

    • Use a Phillips #1 screwdriver to remove three 2mm screws where the battery was located.

    編集

  4. HP ProBook 4520s Hard Drive Replacement: 手順 4、 2の画像 1 HP ProBook 4520s Hard Drive Replacement: 手順 4、 2の画像 2

    • Flip the 4520s over and rotate it so the back is facing you.

    • Use a metal spudger to peel off two rubber caps located on either side of the battery port.

    編集

  5. HP ProBook 4520s Hard Drive Replacement: 手順 5、 1の画像 1

    • Use a Phillips #1 screwdriver to remove the 3mm screws behind the caps.

    編集

  6. HP ProBook 4520s Hard Drive Replacement: 手順 6、 3の画像 1 HP ProBook 4520s Hard Drive Replacement: 手順 6、 3の画像 2 HP ProBook 4520s Hard Drive Replacement: 手順 6、 3の画像 3

    • Rotate the 4520s and then open it with the screen facing you.

    • The switch cover is located above the keyboard. Push the switch cover away from you until it comes loose from the 4520s.

    • Lift the switch cover away from the 4520s and set it aside.

    編集

  8. HP ProBook 4520s Hard Drive Replacement, Keyboard: 手順 7、 2の画像 1 HP ProBook 4520s Hard Drive Replacement, Keyboard: 手順 7、 2の画像 2

    • Use a Phillips #1 screwdriver to remove the two 7mm screws located on either side of the keyboard panel.

    編集

  9. HP ProBook 4520s Hard Drive Replacement: 手順 8、 1の画像 1

    • Slide the keyboard panel away from you to free it from the 4520s.

    • Do not yank the keyboard panel away from the 4520s. This may damage the cable.

    編集

  10. HP ProBook 4520s Hard Drive Replacement: 手順 9、 2の画像 1 HP ProBook 4520s Hard Drive Replacement: 手順 9、 2の画像 2

    • Gently raise up the keyboard and flip it over to reveal a ribbon cable.

    • Release the ribbon cable by carefully lifting the black tab upwards, one side at a time.

    • Remove the cable and lift the keyboard panel up. Set it aside.

    • When reassembling, feed the ribbon cable into the port. Press down on the tab to pinch the cable in place.

    編集

  11. HP ProBook 4520s Hard Drive Replacement, Palm Rest: 手順 10、 2の画像 1 HP ProBook 4520s Hard Drive Replacement, Palm Rest: 手順 10、 2の画像 2

    • Use a Phillips #1 screwdriver to remove the three 3mm screws along the top of the palm rest.

    編集

  12. HP ProBook 4520s Hard Drive Replacement: 手順 11、 2の画像 1 HP ProBook 4520s Hard Drive Replacement: 手順 11、 2の画像 2

    • Slide the palm rest to the right to release it and then rotate it back gently.

    • Do not yank the palm rest away from the 4520s. This may damage the cable.

    編集

  13. HP ProBook 4520s Hard Drive Replacement: 手順 12、 2の画像 1 HP ProBook 4520s Hard Drive Replacement: 手順 12、 2の画像 2

    • Release the ribbon cable by opening the black hinge on the port using a spudger.

    • Remove the cable and set the palm rest aside.

    編集

  14. HP ProBook 4520s Hard Drive Replacement, Hard Drive: 手順 13、 3の画像 1 HP ProBook 4520s Hard Drive Replacement, Hard Drive: 手順 13、 3の画像 2 HP ProBook 4520s Hard Drive Replacement, Hard Drive: 手順 13、 3の画像 3

    • The hard drive is contained in the housing on the lower right.

    • Remove two 5mm screws on the left using a Phillips #1 screwdriver.

    • Fully loosen the captive screw on the right using a Phillips #1 screwdriver.

    編集

  15. HP ProBook 4520s Hard Drive Replacement: 手順 14、 2の画像 1 HP ProBook 4520s Hard Drive Replacement: 手順 14、 2の画像 2

    • Disconnect the hard drive by pulling the tab to the right.

    • Lift the housing out from the 4520s.

    編集

  16. HP ProBook 4520s Hard Drive Replacement: 手順 15、 2の画像 1 HP ProBook 4520s Hard Drive Replacement: 手順 15、 2の画像 2

    • Use a Phillips #1 screwdriver to remove the four 3mm screws on the sides of the housing.

    編集

  17. HP ProBook 4520s Hard Drive Replacement: 手順 16、 1の画像 1

    • Lift the housing away from the hard drive.

    • The hard drive is 2.5".

    編集
終わりに

To reassemble your device, follow these instructions in reverse order.

52 の人々がこのガイドを完成させました。

作成者

5人の作成者と共同で作成されました。

May Lin

メンバー登録日: 09/21/16

837 ポイント

1ガイドが承認済み

バッジ: 15

+12 個以上のバッジ

チーム

UC Davis, Team 1-3, Oliver Fall 2016 UC Davis, Team 1-3, Oliver Fall 2016人のメンバー

UCD-OLIVER-F16S1G3

5 メンバー

8のガイドは作成済み

5 件のコメント

is it 2.5" HDD ?

Bf Soldier - 返信

Yes. I should have included that.

Robert Spencer Harrison -

Thank you so much lol

You taught me that i didn’t have to throw and break this darn machine to get the hard drive out :P

M

Maria Sergent - 返信

Thank you!

This guide works well for the 4320s as well, though there are a few small differences.

The battery compartment has 4 screws and there are none on the back.

The keyboard is held by 4 screws.

The touchpad has the same type of connector as the keyboard.

The hard drive cage is held by a #1 Philips and two #0 Philips instead of #1.

Carl - 返信

Thank you kindly for such a easy to follow step by step tutorial. Never thought this rooky would be able to repair my own laptop

You guys rock

Eugene B - 返信

コメントを追加

統計データ:

過去 24時間: 4

過去 7 日: 37

過去 30 日: 144

今までの合計 38,499