はじめに

How to remove and replace the HDD on an HP ProBook 440 G1.

パーツ

パーツは必要ありません。

  1. Make sure the laptop is turned off  before you start.
    • Make sure the laptop is turned off before you start.

    • Push and hold the release tab on the right and left toward the center.

  2. Pull the battery out.
    • Pull the battery out.

    • Push and hold the release tabs on the right and left toward the center again.

    • Slide the backplate off.

    • Locate the hard drive, opposite the battery across from the wireless card.

    • Remove all four Phillips #00 screws that hold the hard drive in place.

    • Lift up on the outer part of the hard drive.

    • Pull the hard drive out.

    • Remove the four Phillips #00 screws holding the HDD in the HDD cover.

    • The HDD should slide out after all screws are removed.

まとめ

To reassemble your device, follow these instructions in reverse order.

Ethan A Courtney

メンバー登録日: 2018年10月24日

827 ポイント

7のガイドは作成済み

チーム

Purdue University Northwest, Team S1-G4, Hingst Fall 2018 Purdue University Northwest, Team S1-G4, Hingst Fall 2018人のメンバー

PNW-HINGST-F18S1G4

1 メンバー

7のガイドは作成済み

統計データを表示:

過去 24時間: 0

過去 7 日: 3

過去 30 日: 34

今までの合計 38