Shut the device off. Lift the top cover of the scanner. Carefully, pry the plastic frame surrounding the glass away from the printer hood using a plastic prying tool.
  • Shut the device off.

  • Lift the top cover of the scanner.

  • Carefully, pry the plastic frame surrounding the glass away from the printer hood using a plastic prying tool.

  • Pull the frame out.

コメントを追加する

Unscrew the two screws that fasten the frame to the printer hood. Use a T10 screwdriver
  • Unscrew the two screws that fasten the frame to the printer hood. Use a T10 screwdriver

コメントを追加する

Pushing the clip behind the cover piece in, pull the cover piece outwards. Pushing the clip behind the cover piece in, pull the cover piece outwards.
  • Pushing the clip behind the cover piece in, pull the cover piece outwards.

コメントを追加する

Remove the two screws on the front of the printer with a T10 screwdriver. The first is inside the power button panel space and the second is across the printer slider.
  • Remove the two screws on the front of the printer with a T10 screwdriver.

    • The first is inside the power button panel space and the second is across the printer slider.

コメントを追加する

Pull the circuit board from the power button panel space.
  • Pull the circuit board from the power button panel space.

  • Unplug the small ribbon cable from the circuit board.

コメントを追加する

Pull the memory card reader's circuit board out of its slot. Detach the rainbow connector from the back of the circuit board.
  • Pull the memory card reader's circuit board out of its slot.

  • Detach the rainbow connector from the back of the circuit board.

コメントを追加する

Press the clip directly behind the TouchSmart panel and pull the panel up. Disconnect the ribbon cable from the TouchSmart panel. This detaches the panel from the printer body.
  • Press the clip directly behind the TouchSmart panel and pull the panel up.

  • Disconnect the ribbon cable from the TouchSmart panel. This detaches the panel from the printer body.

  • Do not hesitate to use force to remove the TouchSmart panel.

コメントを追加する

Grip the printer hood and pull upward.
  • Grip the printer hood and pull upward.

コメントを追加する

With the top half of the printer separated, lift the upper section with the scanner glass away from the lower section of the printer.
  • With the top half of the printer separated, lift the upper section with the scanner glass away from the lower section of the printer.

コメントを追加する

With the glass facing upwards, remove the screw holding the glass in place. With the glass facing upwards, remove the screw holding the glass in place.
  • With the glass facing upwards, remove the screw holding the glass in place.

コメントを追加する

Lift the glass up and away from the printer.
  • Lift the glass up and away from the printer.

  • Handle glass with care.

  • Replace the broken glass piece with the replacement glass

コメントを追加する

まとめ

To reassemble your device, follow these instructions in reverse order.

ある他の人がこのガイドを完成しました。

garrett hall

メンバー登録日: 2012年09月26日

19 ポイント

2のガイドは作成済み

チーム

Cal Poly, Team 2-11, Propen Fall 2012 Cal Poly, Team 2-11, Propen Fall 2012人のメンバー

CPSU-PROPEN-F12S2G11

4 メンバー

6のガイドは作成済み

コメントを追加する

統計データを表示:

過去 24時間: 0

過去 7 日: 0

過去 30 日: 4

今までの合計 2,296