はじめに

When keyboards become worn or unresponsive, it's typically time to replace them. Replacing a keyboard can be especially difficult, as it's normally secured by many screws. This guide outlines all the steps needed to access the keyboard.

パーツ

パーツは必要ありません。

  1. Turn the laptop over to expose the bottom side.
    • Turn the laptop over to expose the bottom side.

    • Locate the battery removal switch next to the battery compartment

    • Important: Before doing any repairs on the laptop, make sure it is completely powered down and unplugged.

    コメントを追加する

  2. Slide the switch all the way to the left to release the battery.  The battery should pop up.
    • Slide the switch all the way to the left to release the battery. The battery should pop up.

    • Lift the battery out.

    コメントを追加する

    • Remove the six 5 mm screws in the battery compartment using Phillips #1 screwdriver.

    • Remove the 7mm keyboard screw located towards the center of the laptop with a Phillips #1 screwdriver.

    コメントを追加する

  3. Spread Fixmas Cheer
    Get $12 off your purchase of $50 or more with code FIXMAS12
    Spread Fixmas Cheer
    Get $12 off your purchase of $50 or more with code FIXMAS12
    • Flip the laptop over and open the lid.

    • Lift out the plastic panel containing the power button and flip it over.

    • Be careful, the panel is still attached by a small ribbon cable.

    コメントを追加する

    • Locate the ribbon cable attached to the underside of the plastic panel.

    • Using a spudger, unplug the ribbon cable by pushing the brown tab away from circuit board and sliding the ribbon out with your hand.

    • Set the plastic panel aside.

    コメントを追加する

    • Using a Phillips #1 screwdriver, remove the three 5mm screws holding the keyboard in place.

    • Carefully lift the keyboard up (no more than a few cm) and slide it forward, towards the laptops monitor to reveal another larger ribbon cable.

      • Be extremely careful as the keyboard is still attached to the computer by the larger ribbon cable.

    コメントを追加する

    • Use a spudger to push the black tab forward and slide it away from the white connector.

    • Gently pull the ribbon cable from the connector housing.

    • Remove the keyboard.

    コメントを追加する

まとめ

To reassemble your device, follow these instructions in reverse order.

ある他の人がこのガイドを完成しました。

Erik Hoffnagle

メンバー登録日: 2013年04月11日

736 ポイント

3のガイドは作成済み

チーム

Cal Poly, Team 10-32, Maness Winter 2014 Cal Poly, Team 10-32, Maness Winter 2014人のメンバー

CPSU-MANESS-W14S10G32

4 メンバー

6のガイドは作成済み

コメント1件

Please I have a problem with my hp laptop the keyboard and there is noise on it, repair it automatic. thanks you

Clement Glah - 返信

コメントを追加する

統計データを表示:

過去 24時間: 2

過去 7 日: 4

過去 30 日: 22

今までの合計 2,521