Ensure the device is powered down and unplugged.
  • Ensure the device is powered down and unplugged.

  • Turn the device upside down with the battery compartment facing you.

  • Slide the black slider to the right and lift the battery out of its compartment.

コメントを追加する

Locate and remove the six Phillips PM2.5×7.0 screws around the perimeter of the back plate.
  • Locate and remove the six Phillips PM2.5×7.0 screws around the perimeter of the back plate.

    • These screws do not completely detach from the device when unscrewed.

コメントを追加する

Use the plastic opening tool to lift up the back plate and set it aside. Use the plastic opening tool to lift up the back plate and set it aside.
  • Use the plastic opening tool to lift up the back plate and set it aside.

コメントを追加する

Locate the wifi card to the right of the RAM.
  • Locate the wifi card to the right of the RAM.

コメントを追加する

Unplug antenna cables 1 and 2 from their leads.
  • Unplug antenna cables 1 and 2 from their leads.

    • Antenna cable 3 is not used.

コメントを追加する

Remove the two Phillips head screws located on the battery compartment side of the wifi card.
  • Remove the two Phillips head screws located on the battery compartment side of the wifi card.

コメントを追加する

Gently lift the wifi card up to a 45 degree angle from the side with screws.
  • Gently lift the wifi card up to a 45 degree angle from the side with screws.

コメントを追加する

Unplug the wifi card. Unplug the wifi card.
  • Unplug the wifi card.

コメントを追加する

These next steps are for installing your replacement wifi card. These steps are very important to ensure that you do not damage your device.
  • These next steps are for installing your replacement wifi card. These steps are very important to ensure that you do not damage your device.

  • Fully insert the replacement wifi card at a 45 degree angle, ensuring that the notch on the card lines up with the peg on the plug.

コメントを追加する

Gently push the wifi card down until the screws can be replaced.
  • Gently push the wifi card down until the screws can be replaced.

コメントを追加する

Connect the antenna cable 1 with lead 1 and connect antenna cable 2 with lead 2.
  • Connect the antenna cable 1 with lead 1 and connect antenna cable 2 with lead 2.

    • Wire 1 needs to be connected to lead 1 and wire 2 needs to be connected to lead 2.

    • Wire 3 and lead 3 are not used.

コメントを追加する

まとめ

To reassemble your device, follow these instructions in reverse order.

2 の人々がこのガイドを完成させました。

Anmol Mathur

メンバー登録日: 2014年04月14日

291 ポイント

2のガイドは作成済み

チーム

Cal Poly, Team 12-34, Maness Spring 2014 Cal Poly, Team 12-34, Maness Spring 2014人のメンバー

CPSU-MANESS-S14S12G34

4 メンバー

7のガイドは作成済み

コメントを追加する

統計データを表示:

過去 24時間: 0

過去 7 日: 4

過去 30 日: 24

今までの合計 1,099