はじめに

Replace the LCD in your HP Pavilion dv6000.

Remove rubber screw covers from the LCD screen. The top covers pop off with a fingernail but the two on the bottom may require a screwdriver or flat tool.
  • Remove rubber screw covers from the LCD screen. The top covers pop off with a fingernail but the two on the bottom may require a screwdriver or flat tool.

  • Remove the six 7.15mm screws underneath the stoppers. There are four on top and two on bottom.

コメントを追加する

Press the tabs on the sides of the screen in and pop the plastic off. Careful, the plastic is very flimsy and may break.
  • Press the tabs on the sides of the screen in and pop the plastic off. Careful, the plastic is very flimsy and may break.

コメントを追加する

  • Remove the two screws (5.8mm) on either side of the LCD near the hinge. Remove the screws on the outermost side first.

コメントを追加する

  • Take out the two 3.58mm screws on the LCD at the top (one on each edge).

コメントを追加する

  • Hold on to the LCD screen to prevent it from falling over and remove the two 3.58mm screws on the sides at the bottom.

コメントを追加する

  • Let the screen gently rest on the keyboard.

  • Remove the tape from the ribbon.

  • Stop here and check the cable

コメントを追加する

まとめ

To reassemble your device, follow these instructions in reverse order.

13 の人々がこのガイドを完成させました。

Ben Hirsch

メンバー登録日: 2010年10月05日

3,607 ポイント

10のガイドは作成済み

チーム

Cal Poly, Team 21-33, Regan Fall 2010 Cal Poly, Team 21-33, Regan Fall 2010人のメンバー

CPSU-REGAN-F10S21G33

4 メンバー

10のガイドは作成済み

コメント1件

after replacing my cracked screen the back light does not show again

firelionkofi - 返信

コメントを追加する

統計データを表示:

過去 24時間: 0

過去 7 日: 19

過去 30 日: 102

今までの合計 35,629