修理を始めるには コミュニティ ストア

HP Pavilion Wave 600-a014 Mouse and Keyboard Replacement

はじめに

HP Pavilion Wave comes with a pair of built-in mouse and keyboard. This guide shows you how to replace them without using any additional USB-port for your mouse and keyboard.

必要な工具と部品

  1. HP Pavilion Wave 600-a014 Mouse and Keyboard Replacement, Front IO Board: 手順 1、 2の画像 1 HP Pavilion Wave 600-a014 Mouse and Keyboard Replacement, Front IO Board: 手順 1、 2の画像 2

    • Turn over the computer and remove the rubber feet.

    • Remove the 8mm Philips screws indicated in red circles with a Philips #0 screwdriver.

    • Use a pry tool and lift the lid.

    編集

  2. HP Pavilion Wave 600-a014 Mouse and Keyboard Replacement: 手順 2、 2の画像 1 HP Pavilion Wave 600-a014 Mouse and Keyboard Replacement: 手順 2、 2の画像 2

    • Pry open the casing from the back of the IO panel, as shown in the pictures.

    編集

  4. HP Pavilion Wave 600-a014 Mouse and Keyboard Replacement: 手順 3、 2の画像 1 HP Pavilion Wave 600-a014 Mouse and Keyboard Replacement: 手順 3、 2の画像 2

    • Finally, remove the two cables circled in red from the front IO panel.

    編集

  5. HP Pavilion Wave 600-a014 Mouse and Keyboard Replacement, Mouse and Keyboard adapter: 手順 4、 1の画像 1

    • Locate a blue USB adapter on the left side of the hard disk compartment.

    編集

  6. HP Pavilion Wave 600-a014 Mouse and Keyboard Replacement: 手順 5、 2の画像 1 HP Pavilion Wave 600-a014 Mouse and Keyboard Replacement: 手順 5、 2の画像 2

    • Take off the USB with gentle but firm pressure.

    • This is a single USB adapter for both mouse and keyboard, so you must get a wireless mouse and keyboard pair, or you will have to use the extra USB for the other one.

    編集
終わりに

To reassemble your device, follow these instructions in reverse order.

4 の人々がこのガイドを完成させました。

作成者

1人の作成者と共同作成されました。

Kyaw Soe

メンバー登録日: 09/27/17

321 ポイント

2のガイドは作成済み

バッジ: 10

+7 個以上のバッジ

チーム

Cal Poly, Team S8-G4, Banghart Fall 2017 Cal Poly, Team S8-G4, Banghart Fall 2017人のメンバー

CPSU-BANGHART-F17S8G4

4 メンバー

5のガイドは作成済み

3 件のコメント

Seems like there might be enough room for a usb 2 port hub/splitter (such as Onvian USB Splitter Cable Male to 2 Female Adapter USB) to add an additional usb dongle (such an RF or Insteon USB)? Can you confirm how much room there are?

thomastranrx - 返信

Since it's a year old project, I forgot most of the dimensions, but from my memory, it would be possible since it's located in a little groove that can probably fit a wire or two. (You can see it in step one picture)

Kyaw Soe - 返信

Can i purchase this dongle anywhere? Is there any documentation on how to pair?

will - 返信

コメントを追加

統計データ:

過去 24時間: 1

過去 7 日: 2

過去 30 日: 4

今までの合計 2,292