はじめに

Replace the keyboard in your HP Mini 1000.

パーツ

パーツは必要ありません。

With the case closed, place the Mini 1000 top-side down on a flat surface. Push both of the battery release latches toward each other.
  • With the case closed, place the Mini 1000 top-side down on a flat surface.

  • Push both of the battery release latches toward each other.

コメントを追加する

Lift the battery out of the Mini 1000 from the edge closest to the release latches.
  • Lift the battery out of the Mini 1000 from the edge closest to the release latches.

コメントを追加する

Remove the following two screws:
  • Remove the following two screws:

    • One 6 mm Phillips screw

    • One 4 mm Phillips screw

コメントを追加する

To facilitate the removal of the keyboard, it is recommended to push the keyboard outwards with one hand through the opening (highlighted in the third picture) located on the backside of the Mini 1000. While pushing through the opening with one hand, grasp the left upper edge with the other hand and slightly pull the keyboard towards you. Once an opening has been established, grasp the keyboard and slowly lift it upwards along the upper perimeter of the top edge.
  • To facilitate the removal of the keyboard, it is recommended to push the keyboard outwards with one hand through the opening (highlighted in the third picture) located on the backside of the Mini 1000.

  • While pushing through the opening with one hand, grasp the left upper edge with the other hand and slightly pull the keyboard towards you.

  • Once an opening has been established, grasp the keyboard and slowly lift it upwards along the upper perimeter of the top edge.

コメントを追加する

Lift the keyboard out of the upper case, minding the cable that is still connecting it to the motherboard.
  • Lift the keyboard out of the upper case, minding the cable that is still connecting it to the motherboard.

コメントを追加する

Use your fingernail or the flat end of a spudger to flip up the retaining flap on the keyboard cable ZIF socket.
  • Use your fingernail or the flat end of a spudger to flip up the retaining flap on the keyboard cable ZIF socket.

  • Be sure you are prying up on the retaining flap, not the socket itself.

  • Pull the cable out of its socket and remove the keyboard.

コメントを追加する

まとめ

To reassemble your device, follow these instructions in reverse order.

5 の人々がこのガイドを完成させました。

Walter Galan

552,990 ポイント

2,839のガイドは作成済み

コメントを追加する

統計データを表示:

過去 24時間: 0

過去 7 日: 4

過去 30 日: 33

今までの合計 8,754