HP Compaq NC6120 Mouse Pad Replacement

はじめに

Replacing the mouse pad may be necessary when the cursor begins to respond sluggishly to movements. This can be done fairly easily after the laptop has been opened up.

必要な工具と部品

手順1 Disassembling HP Compaq NC6120 Laptop

HP Compaq NC6120 Mouse Pad Replacement, Disassembling HP Compaq NC6120 Laptop: 手順 1、 3の画像 1

HP Compaq NC6120 Mouse Pad Replacement, Disassembling HP Compaq NC6120 Laptop: 手順 1、 3の画像 2

HP Compaq NC6120 Mouse Pad Replacement, Disassembling HP Compaq NC6120 Laptop: 手順 1、 3の画像 3

Flip laptop so the backside is facing upwards.
Pull the two plastic switches at the top of the backside of the computer outwards, and remove the battery.

編集

手順2

Remove all 13 screws from the back panel of the computer (includes the two torx screws under the battery and the two under the ram memory panel).
Remove the four screws at the hinge of the computer (also attaching the back panel to the rest of the computer).
All screws are 9.8mm 3.0 flatheads except for the two under the battery which are T9 torx.

編集

手順3

Open up the laptop so that the screen is facing towards you. Push the monitor back until it is flat, parallel to the keyboard.

編集

手順4

Using the iFixit opening tool, remove the plastic panel located between the keyboard and monitor. It should pop off easily with the spudger and can then be pulled away.

編集

手順5

Remove the white cable attached to the just-removed plastic panel from the motherboard.

編集

手順6

Flip the keyboard away from the monitor, rotating it so that the keys are face down on the mousepad. Remove the black cord at the bottom of the keyboard that connects it to the motherboard. The keyboard is now free and can be removed.

編集

手順7

HP Compaq NC6120 Mouse Pad Replacement: 手順 7、 3の画像 3

Remove the two 9.8mm 3.0 flathead screws. There is one at each of the hinges.

編集

手順8

HP Compaq NC6120 Mouse Pad Replacement: 手順 8、 3の画像 3

Unplug the black cable with rectangular white plastic head from the motherboard. It is located at the top left of the motherboard, directly below the left hinge.

編集

手順9

Pull the monitor directly upwards from where it lay. The two metal hinges should easily slide out of their holes and the monitor will be disconnected from the motherboard.

編集