リペアコミュニティに参加 - アカウントの作成

はじめに

The cameras are directly attached to the motherboard through web cam cables. In order to access those cables to remove the cameras, the battery must be removed first. This guide also requires unsoldering the battery connections from the motherboard.

必要な工具と部品

手順1 Back Panel

HP 10 2101 Camera Replacement, Back Panel: 手順 1、 1の画像 1

Identify the SD card port.

翻訳

FixBotに聞いてみる

手順2

Insert the smallest plastic opening tool into the SD card port. Gently pry until the back panel separates from the screen panel.
Do not insert opening tool too far. Avoid making contact with the metal inside the port.

翻訳

FixBotに聞いてみる

手順3

Slide the opening tool along the seam between the back panel and the screen panel, prying the panels apart as you move around the edges.

翻訳

FixBotに聞いてみる

手順4

Separate the back panel from the rest of the device.

翻訳

FixBotに聞いてみる

手順5 Battery

HP 10 2101 Camera Replacement, Battery: 手順 5、 1の画像 1

Desolder the battery connectors from the motherboard.

翻訳

FixBotに聞いてみる

手順6

Pull the bright blue-green tabs to remove the battery from the rest of the device.
Pulling the tabs may not fully disconnect the battery from the metal display casing.

翻訳

FixBotに聞いてみる

手順7

If the previous step is unsuccessful, wedge the smallest plastic opening tool between the adhesive and the metal display casing.
Wedging may apply unsafe pressure on the battery. Be careful not to puncture the battery.

翻訳

FixBotに聞いてみる

手順8 Camera

HP 10 2101 Camera Replacement, Camera: 手順 8、 1の画像 1

Peel off the metal mesh tape with the plastic opening tool.

翻訳

FixBotに聞いてみる

手順9

Disconnect the zero insertion force (ZIF) cable. Use the tip of the spudger or your fingernail to flip up the small white locking flap. Then, you can safely pull the cable out.
Repeat this process for the second connection port.
Be sure to pry up on the hinged flap, not the connector socket.