メインコンテンツにスキップ

GoPro HD Hero2 Rear Case Replacement

必要条件のみ
この修理ガイドは、他のガイドの前提条件として使用されます。それ自体は不完全で、単独で使用されることはありません。

必要な工具と部品

  1. GoPro HD Hero2 Rear Case Replacement, Rear Case: 手順 1、 1の画像 1
    • Remove the four Phillips #00 screws securing the rear case to the rest of the device:

    • Two 5.5 mm coarse thread screws.

    • Two 4.4 mm fine thread screws.

  2. GoPro HD Hero2 Rear Case Replacement: 手順 2、 2の画像 1 GoPro HD Hero2 Rear Case Replacement: 手順 2、 2の画像 2
    • Slide the edge of a plastic opening tool underneath the sticker on the rear cover and gently peel the sticker up.

    • Once you have enough of the sticker peeled up with the plastic opening tool, grab an edge of it with your fingers and pull it off completely.

  3. GoPro HD Hero2 Rear Case Replacement: 手順 3、 2の画像 1 GoPro HD Hero2 Rear Case Replacement: 手順 3、 2の画像 2
    • Grasp the rear case and lift it off of the front case.

    • Do not try to completely remove the rear case yet, as it is still attached by the display port ribbon cable.

  4. GoPro HD Hero2 Rear Case Replacement: 手順 4、 2の画像 1 GoPro HD Hero2 Rear Case Replacement: 手順 4、 2の画像 2
    • Using a plastic opening tool or your fingernail, flip up the locking tab on the SD board ribbon cable ZIF connector on the motherboard assembly.

    • Be careful that you are prying on the locking tab, and not the connector itself.

    • Use a pair of tweezers to remove the SD board ribbon cable from its connector on the motherboard.

  5. GoPro HD Hero2 Rear Case Replacement: 手順 5、 3の画像 1 GoPro HD Hero2 Rear Case Replacement: 手順 5、 3の画像 2 GoPro HD Hero2 Rear Case Replacement: 手順 5、 3の画像 3
    • Lift the speaker out of the rear case with the tip of a spudger.

    • Remove the rear case.

終わりに

To reassemble your device, follow these instructions in reverse order.

作成者

1人の作成者と共同作成されました。

David Hodson

メンバー登録日: 04/13/10

150,352 ポイント

127のガイドは作成済み

0 件のコメント

コメントを追加

統計データ:

過去 24時間: 0

過去 7 日: 0

過去 30 日: 0

今までの合計 756