Geardup RC Ford Mustang GT Remote Circuit Board Replacement

はじめに

The circuit board of the remote transmits the movement instructions to the car. If the remote isn't transmitting, the following steps will show you how to replace the circuit board.

Note: This guide will involve soldering. For information on how to solder, please visit iFixit's Soldering Skills page.

必要な工具と部品

手順1 Lower Remote Control

Geardup RC Ford Mustang GT Remote Circuit Board Replacement, Lower Remote Control: 手順 1、 3の画像 1

Geardup RC Ford Mustang GT Remote Circuit Board Replacement, Lower Remote Control: 手順 1、 3の画像 2

Geardup RC Ford Mustang GT Remote Circuit Board Replacement, Lower Remote Control: 手順 1、 3の画像 3

Remove the 5mm Phillips #0 screw from the remote control.
Using the tab, lift the battery cover from the remote control to expose the battery.

編集

手順2 Remote Circuit Board

Geardup RC Ford Mustang GT Remote Circuit Board Replacement, Remote Circuit Board: 手順 2、 2の画像 1

Geardup RC Ford Mustang GT Remote Circuit Board Replacement, Remote Circuit Board: 手順 2、 2の画像 2

Unscrew the six 5mm Phillips #0 screws on the back of the remote
Separate the back of the remote from the front panel.
During re-assembly, make sure the plastic button covers on the front panel align with the buttons on the back panel. If they do not, the buttons may be forced into an always "pressed" state.

編集

手順3

Remove the two left and right buttons from their insets in the controller.

編集

手順4

Remove the 5mm Phillips #0 screw that connects the antennae to the circuit board.

編集

手順5

Unscrew 5mm Phillips #0 screw located at the bottom of the board in the center.
Remove the circuit board from the casing.

編集

手順6

Make note of where each wire connects to the circuit board for re-assembly as they will be removed in the next step.
Using the copper solder wick, remove the solder connecting the nine wires to the circuit board.

編集