はじめに

Replace a broken screen in your Gateway SA1 laptop.

  1. Move the latch to the right of the battery to unlock.
    • Move the latch to the right of the battery to unlock.

    コメントを追加する

  2. Slide the latch on the left directly below the battery to unlock and pull out the battery as shown.
    • Slide the latch on the left directly below the battery to unlock and pull out the battery as shown.

    • The latch must be held in position to remove the battery.

    コメントを追加する

    • Remove the hinge covers by lifting each with the sharp point of the spudger.

      • Notice that the middle cover has a different shape and is more difficult to remove.

    コメントを追加する

    • Remove the six screw covers on the front bezel with the sharp point of the spudger.

      • The bottom two are more difficult to remove.

    コメントを追加する

    • Remove the six 5.9 mm Philips screws securing the screen bezel.

    コメントを追加する

    • Remove the front bezel by prying it off with the wedged end of the spudger.

    • Verify that your spudger does not touch the LCD.

      • The screen inverter is now exposed below the LCD.

    コメントを追加する

    • Remove the single 3.8mm Phillips screw mounting the screen inverter to the computer.

    コメントを追加する

    • Use your finger, or the spudger, to pry the inverter board out.

      • This exposes the wires behind it.

    コメントを追加する

    • Unplug the LCD back light cables from the right side of the screen inverter.

    コメントを追加する

    • Remove the six screws that mount the screen to the hinge mounts.

      • Two 2.5 mm Phillips screws.

      • Four 3.8 mm Phillips screws.

    コメントを追加する

    • Unplug the cable from the webcam board.

      • Be gentle, do not use excessive force or you may break the connection.

    コメントを追加する

    • Separate the screen from the display cover.

      • Do not touch the back of the screen.

    コメントを追加する

    • Remove the three tape strips that hold down the cables.

      • Be careful not to tear any of the tape. The piece holding down the webcam wires is especially delicate.

    コメントを追加する

    • Unplug the display data cable from the screen connector.

      • This connection is very fragile; do not use excessive force.

      • The screen should now be free from all wire connections.

    コメントを追加する

    • Remove the four 2.8 mm Phillips screws that secure the screen to the mounting bracket using a screwdriver.

      • There will be two screws on either side of the mounting bracket.

    コメントを追加する

    • You can now remove and replace the screen.

    コメントを追加する

まとめ

To reassemble your device, follow these instructions in reverse order.

2 の人々がこのガイドを完成させました。

Diego Carteno

メンバー登録日: 2010年04月15日

247 ポイント

7のガイドは作成済み

チーム

Cal Poly, Team 24-20, Regan Spring 2010 Cal Poly, Team 24-20, Regan Spring 2010人のメンバー

CPSU-REGAN-S10S24G20

4 メンバー

7のガイドは作成済み

コメントを追加する

統計データを表示:

過去 24時間: 0

過去 7 日: 3

過去 30 日: 13

今までの合計 18,124