Garmin inReach Mini Back Case Replacement

はじめに

This guide demonstrates how to replace the back case of the Garmin inReach Mini (model number 5HT094452). This guide is a prerequisite for users who are attempting to replace the battery or motherboard of the device. The battery of the device is located inside the back case. Removing the back hard case involves removing a number of small screws, and it is crucial to keep careful track of these pieces so that the case can be replaced properly.

必要な工具と部品

手順1 Nylon Strap

Garmin inReach Mini Back Case Replacement, Nylon Strap: 手順 1、 1の画像 1

Place the device on a level surface with the back hard case facing up.

編集

手順2

Garmin inReach Mini Back Case Replacement: 手順 2、 3の画像 3

Use the T5 to remove the 1.9mm screw attached to the nylon strap.
Remove the nylon strap.

編集

手順3 Back Case

Garmin inReach Mini Back Case Replacement, Back Case: 手順 3、 3の画像 1

Garmin inReach Mini Back Case Replacement, Back Case: 手順 3、 3の画像 2

Garmin inReach Mini Back Case Replacement, Back Case: 手順 3、 3の画像 3

Remove the five 1.8 mm screws located on the top, sides, and bottom corners of the backside of the device.

編集

手順4

Garmin inReach Mini Back Case Replacement: 手順 4、 3の画像 3

Lastly, lift the protective cap on the side of the device that states "SOS". Slowly pull it to the right in order to remove the back hard case.

編集

手順5

Garmin inReach Mini Back Case Replacement: 手順 5、 3の画像 3

この手順で使用する道具：

Tweezers

$4.99

購入する

Using the precision tweezers with the round tips, detach the battery connector from the motherboard.
Disconnecting the battery stops the flow of power into the motherboard. This is for your own safety.
If utilizing this guide as a prerequisite to replacing the motherboard, it is crucial not to damage the cable connecting the battery to the motherboard. When the new motherboard is introduced, it will need to be reconnected with that cable.