メインコンテンツにスキップ

このバージョンは誤った内容を含んでいる可能性があります。最新の承認済みスナップショットに切り替えてください。

必要な工具と部品

  1. この手順は未翻訳です。 翻訳を手伝う。

    : 手順 1、 1の画像 1
    • Remove the barcode sticker at the bottom of the device.

  2. この手順は未翻訳です。 翻訳を手伝う。

    : 手順 2、 1の画像 1
    • Remove two 8.4 mm T5 screws from the bottom of the device.

  3. この手順は未翻訳です。 翻訳を手伝う。

    : 手順 3、 2の画像 1 : 手順 3、 2の画像 2
    • Using a plastic opening tool, carefully pry open the device.

    • Open the device carefully, making sure not to damage the gold ribbon cable that connects the screen to the motherboard.

  4. この手順は未翻訳です。 翻訳を手伝う。

    : 手順 4、 2の画像 1 : 手順 4、 2の画像 2
    • Remove the power button.

  5. この手順は未翻訳です。 翻訳を手伝う。

    : 手順 5、 1の画像 1
    • Unscrew the four 6.70 mm screws holding the motherboard in place using a philips #0 screw driver.

  6. この手順は未翻訳です。 翻訳を手伝う。

    : 手順 6、 2の画像 1 : 手順 6、 2の画像 2
    • Lift up the motherboard.

    • Carefully disconnect the battery and motherboard. Slowly wiggling the connection makes it easier to disconnect the battery from the motherboard.

  7. この手順は未翻訳です。 翻訳を手伝う。

    : 手順 7、 2の画像 1 : 手順 7、 2の画像 2
    • Using the plastic opening tool as a wedge, pry the battery from the case. This can be fairly tough as the battery is glued to the case. Don't be afraid to use force and some good leverage.

ゴール

15 の人々がこのガイドを完成させました。

作成者

5人の作成者と共同で作成されました。

Timothy

メンバー登録日: 01/26/12

73 ポイント

3のガイドは作成済み

チーム

Cal Poly, Team 9-3, Regan Winter 2012 Cal Poly, Team 9-3, Regan Winter 2012人のメンバー

CPSU-REGAN-W12S9G3

5 メンバー

4のガイドは作成済み

9 件のコメント

Thanks for this very nicely illustrated guide.

RBStorms - 返信

Thanks for the guide. Used it to open up a Nuvi 265 because the battery had been left to discharge below the protection circuit's limit. Connected the battery leads (Green = ground, Red = voltage, Black = temperature) to a 5v USB charger for ~20 seconds to revive the protection circuit, and the unit is now charging again. If you're going to do this, know the risks. Thermal runaways in lithium batteries can be extremely volatile.

rbol - 返信

Used these instructions to replace battery in my 5-year old Garmin nuvi 205W (which has the same access and internal geometry).

JRedmond - 返信

Thanks, great demonstration.

peter2x4 - 返信

This is great! I have run into a big problem, though. One of the screws is "unthreaded." The head has become smooth, and I can't unscrew it to get the cover off. Is there any way to get it off???

nancyw - 返信

コメントを追加

統計データ:

過去 24時間: 1

過去 7 日: 10

過去 30 日: 62

今までの合計 26,657