メインコンテンツにスキップ

はじめに

Opening the Nuvi and replacing a broken/damaged display.

パーツ

パーツは指定されていません。

  1. Peel off the sticker from the bottom of the device to reveal two screws. Peel off the sticker from the bottom of the device to reveal two screws.
    • Peel off the sticker from the bottom of the device to reveal two screws.

  2. Remove two T5 Torx screws.
    • Remove two T5 Torx screws.

  3. Insert a plastic opening tool in the gap between the front and rear casing. Carefully work the tool around the gap, separating the two halves of the case.
    • Insert a plastic opening tool in the gap between the front and rear casing.

    • Carefully work the tool around the gap, separating the two halves of the case.

    • Keep the power switch in place while removing the rear case.

  4. iPhoneのバッテリーキット

    Only $29.99

    Buy Now

    iPhoneのバッテリーキット

    Only $29.99

    Buy Now
  5. Apply pressure to the tabs holding the screen in place with the plastic opening tool
    • Apply pressure to the tabs holding the screen in place with the plastic opening tool

  6. Apply pressure to the same tabs again to remove the front of the screen. Apply pressure to the same tabs again to remove the front of the screen.
    • Apply pressure to the same tabs again to remove the front of the screen.

  7. Peel away the material holding the ribbon cable in place. Peeling the sticker halfway will allow you to access the ribbon cable. Removing it fully will allow you to detach the upper case from the lower case.
    • Peel away the material holding the ribbon cable in place.

    • Peeling the sticker halfway will allow you to access the ribbon cable. Removing it fully will allow you to detach the upper case from the lower case.

  8. Disconnect the ribbon cable from the logic board. Make sure to disconnect the cable from both ports.
    • Disconnect the ribbon cable from the logic board.

    • Make sure to disconnect the cable from both ports.

  9. The display consists of two screens which are held together by the ribbon. The display consists of two screens which are held together by the ribbon.
    • The display consists of two screens which are held together by the ribbon.

まとめ

To reassemble your device, follow these instructions in reverse order.

4 の人々がこのガイドを完成させました。

Nick

メンバー登録日: 2010年04月11日

7 ポイント

1ガイドが承認済み

チーム

Cal Poly, Team 25-90, Amido Spring 2010 Cal Poly, Team 25-90, Amido Spring 2010人のメンバー

CPSU-AMIDO-S10S25G90

4 メンバー

9のガイドは作成済み

コメントを追加する

統計データを表示:

過去 24時間: 0

過去 7 日: 1

過去 30 日: 8

今までの合計 10,522