はじめに

Use this repair guide when debris needs to be cleared from the On/Off switch or it needs to be replaced.

Take the battery cover off by releasing the locking tab and hinging the cover away.
  • Take the battery cover off by releasing the locking tab and hinging the cover away.

コメントを追加する

Remove the six back panel screws using a Tri-wing Screwdriver.
  • Remove the six back panel screws using a Tri-wing Screwdriver.

コメントを追加する

  • Remove bottom back panel screw with a Phillips #1 screw driver.

We recommend you change the the screw head to a Phillips 1 so you don't strip the screw. (Something we experienced)

Adriano Agostino - 返信

  • Remove the back panel by pulling away with one hand and the front secured in the other hand.

  • Removal of the back panel may cause shoulder buttons and side panels to come loose and fall off.

コメントを追加する

  • Remove left and right triggers by lifting and pulling them away from the system.

  • Do the same for side panels

  • For finicky or jammed triggers only. Adjust and correct triggers and reassemble. Most jammed triggers are caused by buttons misplaced or jammed in its enclosure.

コメントを追加する

  • Remove the gray On/Off Switch by pulling up and away from the unit. Replace with another switch if necessary.

コメントを追加する

まとめ

To reassemble your device, follow these instructions in reverse order.

3 の人々がこのガイドを完成させました。

Adam

メンバー登録日: 2010年01月20日

634 ポイント

5のガイドは作成済み

チーム

Cal Poly, Team 16-29, Maness Winter 2010 Cal Poly, Team 16-29, Maness Winter 2010人のメンバー

CPSU-MANESS-W10S16G29

5 メンバー

26のガイドは作成済み

コメントを追加する

統計データを表示:

過去 24時間: 3

過去 7 日: 24

過去 30 日: 93

今までの合計 11,882