はじめに

This section describes removing the logic board whole from the case.

Take the battery cover off by releasing the locking tab and hinging the cover away.
  • Take the battery cover off by releasing the locking tab and hinging the cover away.

コメントを追加する

Remove the six back panel screws using a Tri-wing Screwdriver.
  • Remove the six back panel screws using a Tri-wing Screwdriver.

コメントを追加する

  • Remove bottom back panel screw with a Phillips #1 screw driver.

We recommend you change the the screw head to a Phillips 1 so you don't strip the screw. (Something we experienced)

Adriano Agostino - 返信

  • Remove the back panel by pulling away with one hand and the front secured in the other hand.

  • Removal of the back panel may cause shoulder buttons and side panels to come loose and fall off.

コメントを追加する

  • Remove left and right triggers by lifting and pulling them away from the system.

  • Do the same for side panels

  • For finicky or jammed triggers only. Adjust and correct triggers and reassemble. Most jammed triggers are caused by buttons misplaced or jammed in its enclosure.

コメントを追加する

  • Remove the gray On/Off Switch by pulling up and away from the unit. Replace with another switch if necessary.

コメントを追加する

  • Remove the three screws on the circuit board with a Phillips #1 screw driver.

コメントを追加する

  • Pull circuit board away from the front panel by pulling up at the bottom of the circuit board, keeping the top ribbon still connected.

  • Handle with care! The ribbon connecting the circuit board to the LCD screen can easily be damaged and will require replacement if broken.

コメントを追加する

まとめ

To reassemble your device, follow these instructions in reverse order.

2 の人々がこのガイドを完成させました。

Aldo Corona

メンバー登録日: 2010年01月25日

586 ポイント

6のガイドは作成済み

チーム

Cal Poly, Team 16-29, Maness Winter 2010 Cal Poly, Team 16-29, Maness Winter 2010人のメンバー

CPSU-MANESS-W10S16G29

5 メンバー

26のガイドは作成済み

コメントを追加する

統計データを表示:

過去 24時間: 0

過去 7 日: 10

過去 30 日: 25

今までの合計 5,156