はじめに
This guide will show you how to remove the rear housing and begin disassembly of your Furbo Dog Camera (Model:Furbo2). Removing the outer housing allows you to access the inside of your Furbo and fix and replace any parts if necessary. Sometimes separation of the plastic components may be difficult, so be careful not to break your Furbo.
必要な工具と部品
-
-
-
Use a 2.5 mm Flathead screwdriver to remove the four 5 mm screws from the bottom of the Furbo.
-
Use a 2.5 mm Flathead screwdriver to remove the single 5 mm screw under the silver sticker.
-
To reassemble your device, follow these instructions in reverse order.
To reassemble your device, follow these instructions in reverse order.
チーム
University of Alabama, Team 1-1, Bedsole Spring 2022 University of Alabama, Team 1-1, Bedsole Spring 2022人のメンバー
UA-BEDSOLE-S22S1G1
3 メンバー
6のガイドは作成済み
