メインコンテンツにスキップ

はじめに

Before you get started with this procedure, have a place to store screws in an organized fashion. There are many screws involved in this procedure that you don't want to get mixed up.

  1. Use the Phillips PH00 screwdriver to remove all the 0.5mm screws on the side. Use the Phillips PH00 screwdriver to remove all the 0.5mm screws on the side.
    • Use the Phillips PH00 screwdriver to remove all the 0.5mm screws on the side.

  2. Use the Tri-point Y0 screwdriver to remove the two 0.5mm screws on the horizontal axis. Remove the other two 0.5mm screws on the bottom with the PH00 screwdriver.
    • Use the Tri-point Y0 screwdriver to remove the two 0.5mm screws on the horizontal axis.

    • Remove the other two 0.5mm screws on the bottom with the PH00 screwdriver.

  3. Once you unscrew all of the screws, carefully remove the rear casing.
    • Once you unscrew all of the screws, carefully remove the rear casing.

    • Be careful not to pull the rear casing, otherwise you will rip the ribbon cable.

    • Detach the ribbon cable by lifting the tab on the connector.

終わりに

To reassemble your device, follow these instructions in reverse order.

ある他の人がこのガイドを完成しました。

Lizzie Eller

メンバー登録日: 2017年01月25日

422 ポイント

4のガイドは作成済み

チーム

Cal Poly, Team 8-7, Banghart Winter 2017 Cal Poly, Team 8-7, Banghart Winter 2017人のメンバー

CPSU-BANGHART-W17S8G7

4 メンバー

10のガイドは作成済み

0 件のコメント

コメントを追加

統計データを表示:

過去 24時間: 1

過去 7 日: 3

過去 30 日: 7

今までの合計 417