Fujifilm FinePix S4200 Viewfinder Replacement

はじめに

To replace the viewfinder you will need to perform the LCD prerequisite. The viewfinder should be replaced if your camera does not focus or your photos lack composition.

必要な工具と部品

手順1 LCD Screen

Fujifilm FinePix S4200 Viewfinder Replacement, LCD Screen: 手順 1、 1の画像 1

Turn the camera off.
Turn the camera upside down so that the battery compartment is showing.

編集

手順2

Remove the three 4 mm screws from the bottom of the camera with a Phillips #000 screwdriver.

編集

手順3

Rotate camera to the side where the speaker ports are located.
Remove the three 4 mm screws with a Phillips #000 screwdriver.

編集

手順4

Turn the camera to the opposite side where the HDMI port is located.
Remove all five 4 mm screws with a Phillips #000 screwdriver.

編集

手順5

Fujifilm FinePix S4200 Viewfinder Replacement: 手順 5、 3の画像 3

Casing is fragile.
Utilize the plastic opening tool to pry in between the back casing of the camera from the front casing.
Continue this motion around the camera to create a wedge between the front and back casing of the camera.

編集

手順6

Use force to pull apart the back casing from the camera.

編集

手順7

Remove the two 4 mm screws that hold the motherboard and metal plate in place.

編集

手順8

Utilize the plastic opening tool to gently lift the LCD screen away from the metal plate.
Flip over LCD screen so that the left side of the metal plate is visible.

編集

手順9

Rotate the camera vertically so that it is easier to manage.
Use a Phillips #000 screwdriver to remove the two 4mm screws that are located on the metal plate under the LCD screen.

編集

手順10

Detach the metal plate from the motherboard.

編集

手順11

The orange ribbon cable is fragile.
Pull back the small black latch connecting the orange ribbon cable to the motherboard.
Gently remove the LCD screen from the motherboard.