パーツ

パーツは必要ありません。

  1. Locate and remove two 6.4mm screws on the bottom of the camera with a Phillips #00 screwdriver.
    • Locate and remove two 6.4mm screws on the bottom of the camera with a Phillips #00 screwdriver.

    コメントを追加する

  2. Locate the battery door.
    • Locate the battery door.

    コメントを追加する

    • Locate the latch on the battery door marked by the word "BATT." Use your finger to pry it open.

    コメントを追加する

    • Remove the battery from the camera by pulling the battery door outwards.

    コメントを追加する

    • Locate and remove three black 3.80mm screws on the back of the camera with the Phillips #00 screwdriver.

    コメントを追加する

    • Locate and remove the 6.4mm screws located on either side of the camera with a Phillips #00 screwdriver.

    コメントを追加する

    • Locate the film door latch located on the side of the camera.

    • Insert the spudger under the latch.

    • Caution: Be careful during the following step in order to not break any parts within the camera. Prying the latch in any other direction than perpendicular may result in broken parts.

    • Pry the latch upward, applying force perpendicular to the camera.

    コメントを追加する

    • Insert the flat edge of the spudger between the gold front casing and the black back casing.

    • Pry the spudger upward until the black back casing snaps out and is dislodged on that edge of the camera.

    コメントを追加する

    • Squeeze the camera by placing a thumb on the tab marked CE.

    • Pull the back half of the camera firmly away from the camera body.

    コメントを追加する

    • Locate and remove the 3.80mm screw inside the film compartment with the Phillips #00 screwdriver.

    コメントを追加する

    • Pull the front cover off of the camera by lifting the tripod tab over the tripod hole.

    コメントを追加する

    • Locate the film door on the bottom of the camera.

    • Locate the pin that connects the film door to the camera

    コメントを追加する

    • Push the pin from one side with the spudger until it comes out on the opposite side.

    コメントを追加する

    • Grab the pin with the tweezers and gently pull it out.

    • The film door should feel lose.

    コメントを追加する

    • Remove the door with your fingers and discard it.

    • Insert the replacement film door appropriately to fit where the broken door was located.

    コメントを追加する

まとめ

To reassemble your device, follow the instructions from the "Disassembling Fujifilm Endeavor 100ix Outer Casing" guide in reverse order.

Eric Nicolai

メンバー登録日: 2011年01月10日

679 ポイント

6のガイドは作成済み

チーム

Cal Poly, Team 13-5, Forte Winter 2011 Cal Poly, Team 13-5, Forte Winter 2011人のメンバー

CPSU-FORTE-W11S13G5

5 メンバー

6のガイドは作成済み

コメントを追加する

統計データを表示:

過去 24時間: 0

過去 7 日: 0

過去 30 日: 0

今までの合計 1,572