Fluke 77 Series III Front Panel Replacement - iFixit 修理ガイド

はじめに

This is a guide for replacing the front panel of the Fluke 77 Series III Multimeter. Front panel removal is a prerequisite-only guide for replacing all other parts of the Fluke 77 Series III Multimeter.

必要な工具と部品

手順1 Front Panel

Fluke 77 Series III Front Panel Replacement, Front Panel: 手順 1、 1の画像 1

Be sure any test leads are out and the multimeter is off before opening the device.
Turn the multimeter so it is display side down.
Lift up the back stand of the device by putting your thumb in the curved well at the bottom of the device, so you have access to the two covered screws below.

手順2

Fluke 77 Series III Front Panel Replacement: 手順 2、 1の画像 1

Use your Phillips #2 Screwdriver to remove the four black 21 mm Phillips #2 screws.

手順3

Fluke 77 Series III Front Panel Replacement: 手順 3、 2の画像 1

Fluke 77 Series III Front Panel Replacement: 手順 3、 2の画像 2

Turn the Fluke 77 Series III Multimeter back over so that it is display side up.
Pry the front panel from the back panel at the seam.
If the front panel does not come off easily, move a plastic opening tool along the seam until the panels separate completely.

終わりに

To reassemble your device, follow these instructions in reverse order.

作成者

6人の作成者と共同で作成されました。

Kishan Patel

メンバー登録日: 01/31/14

734 ポイント

3のガイドは作成済み

+10 個以上のバッジ

チーム

Cal Poly, Team 2-10, Amido Winter 2014 Cal Poly, Team 2-10, Amido Winter 2014人のメンバー

CPSU-AMIDO-W14S2G10

4 メンバー

10のガイドは作成済み

0 件のコメント

統計データ:

過去 24時間: 0

過去 7 日: 0

過去 30 日: 0

今までの合計 90