Fluance RT83 Belt Replacement

はじめに

The Fluance RT83 turntable is belt driven. This means that the motor that spins your records is attached to your turntable's platter by a belt.

The rubber belt on a Fluance turntable plays an essential role in preventing the platter which the record lays on from receiving any vibration produced by the motor.

If your turntable is having difficulty playing at your desired speed, or playing at all, it's likely time to replace your turntable's belt.

I will be using a Fluance RT83 for this guide, however, the guide will be applicable to Fluance's RT82, 83, 84, and 85 models.

Follow these simple steps to replace the belt on your Fluance turntable.

必要な工具と部品

手順1 Belt

Fluance RT83 Belt Replacement, Belt: 手順 1、 1の画像 1

Unplug the turntable.

編集

手順2

Lock the tonearm in place with the tonearm clip.
If the tonearm is not locked in place, it could move around and potentially damage the needle

編集

手順3

Lift the rubber mat and place it to the side.
The rubber mat should come off easily, as it is simply resting on top of the metal platter.

編集

手順4

Unhook the drive belt from the motor pulley.
The drive belt is carefully wrapped around the motor pulley, so it is important to unhook it gently.

編集

手順5

Remove the drive belt from the metal platter.

編集

手順6

Grab the new drive belt.
Wrap the new drive belt around the motor pulley.
Note: When reassembling the turntable, don't forget to wrap the new drive belt around the motor pulley.

編集

手順7

Once your drive belt is hooked around the motor pulley, continue wrapping the drive belt around the entire metal platter.
If you are having difficulty wrapping the new drive belt around the metal platter, go very slowly and gently. Patience may be required for this step.

編集

手順8

Make sure your drive belt is flush against the platter.
It is very important there are no twists in your drive belt.

編集

手順9

Give your metal platter a gentle spin clockwise.
When spinning, the platter should continue to spin for a few seconds on its own.
If your metal platter is able to spin with the new drive belt attached, you have successfully installed your drive belt.