はじめに

Replace the small wheel or 'roller' on the bottom of the Eureka.

Press the black separator switch and lightly pull the bottom half away from the top. Press the black separator switch and lightly pull the bottom half away from the top.
  • Press the black separator switch and lightly pull the bottom half away from the top.

コメントを追加する

Remove the vacuum head from the lower half of the body. Remove the vacuum head from the lower half of the body.
  • Remove the vacuum head from the lower half of the body.

コメントを追加する

Turn the vacuum head wheels up and remove all seven 13.9mm screws from the bottom using a #2 Phillips head screwdriver. Separate the top and bottom of the vacuum head. Set the top aside. Separate the top and bottom of the vacuum head. Set the top aside.
  • Turn the vacuum head wheels up and remove all seven 13.9mm screws from the bottom using a #2 Phillips head screwdriver.

  • Separate the top and bottom of the vacuum head. Set the top aside.

コメントを追加する

Turn the vacuum head's bottom over so that the inside of the head is facing up. Using a Phillips #00 screwdriver, press down on metal bar of the roller on one side until it releases from the housing.
  • Turn the vacuum head's bottom over so that the inside of the head is facing up.

  • Using a Phillips #00 screwdriver, press down on metal bar of the roller on one side until it releases from the housing.

    • Turn the vacuum head's bottom over and pull at the roller and bar until they are completely out of the housing.

コメントを追加する

Press the new bar and roller into place.
  • Press the new bar and roller into place.

    • Replace the screws.

コメントを追加する

ゴール

Jennifer Sheils

メンバー登録日: 2013年09月07日

4 ポイント

2のガイドは作成済み

チーム

University of Maryland, Team 1-1, Gulbrandsen Fall 2013 University of Maryland, Team 1-1, Gulbrandsen Fall 2013人のメンバー

UMD-GULBRANDSEN-F13S1G1

3 メンバー

6のガイドは作成済み

コメントを追加する

統計データを表示:

過去 24時間: 0

過去 7 日: 0

過去 30 日: 0

今までの合計 118