メインコンテンツにスキップ

パーツ

パーツは指定されていません。

  1. Make sure that your vacuum is unplugged from a power source. Press the black button just below the handle and extend the pole fully.
    • Make sure that your vacuum is unplugged from a power source.

    • Press the black button just below the handle and extend the pole fully.

  2. Press the black separator switch to separate the top and bottom halves of the vacuum. Press the black separator switch to separate the top and bottom halves of the vacuum.
    • Press the black separator switch to separate the top and bottom halves of the vacuum.

  3. iPhoneのバッテリーキット

    Only $29.99

    Buy Now

    iPhoneのバッテリーキット

    Only $29.99

    Buy Now
  4. Use a #2 Phillips head screwdriver to remove six 13.9mm screws from the side of the motor housing (top half) as shown. Remove two 14.1mm screws from the front face of the housing. You are now all set to open the housing. Keep a watchful eye on the two screws from the front face. These two have additional collars to their necks and will not fit in any of the other holes, yet no other screw will fit in their spots without the collar.
    • Use a #2 Phillips head screwdriver to remove six 13.9mm screws from the side of the motor housing (top half) as shown.

    • Remove two 14.1mm screws from the front face of the housing. You are now all set to open the housing.

    • Keep a watchful eye on the two screws from the front face. These two have additional collars to their necks and will not fit in any of the other holes, yet no other screw will fit in their spots without the collar.

  5. Pull out the button and the spring attached to it.
    • Pull out the button and the spring attached to it.

    • Swap the old spring with a new one.

  6. Insert the new spring and button back into the right slot as shown in the picture.
    • Insert the new spring and button back into the right slot as shown in the picture.

まとめ

To reassemble your device, follow these instructions in reverse order.

Nikhila Vijaybhaskar

メンバー登録日: 2013年09月24日

224 ポイント

2のガイドは作成済み

チーム

University of Maryland, Team 1-1, Gulbrandsen Fall 2013 University of Maryland, Team 1-1, Gulbrandsen Fall 2013人のメンバー

UMD-GULBRANDSEN-F13S1G1

3 メンバー

6のガイドは作成済み

コメントを追加する

統計データを表示:

過去 24時間: 0

過去 7 日: 0

過去 30 日: 0

今までの合計 197