Etekcity Lasergrip 1080 Trigger Replacement

はじめに

This guide will show you how to repair a trigger that has a faulty connection. If the trigger will depress and not return to its original position or if it will not even depress, this will be necessary. The tool needed is a screwdriver. There are no hazards in this guide.

必要な工具と部品

手順1 Battery

Etekcity Lasergrip 1080 Trigger Replacement, Battery: 手順 1、 1の画像 1

Pull the battery cover away from the handle by gripping near the thumb groove.

編集

手順2

Gently pull the battery out of the handle.
Excessive force could damage wires.

編集

手順3

Disconnect the battery by pulling the connector away from it.
Positive first
Negative second
When replacing the battery, this order is reversed.

編集

手順4 Buttons

Etekcity Lasergrip 1080 Trigger Replacement, Buttons: 手順 4、 2の画像 1

Etekcity Lasergrip 1080 Trigger Replacement, Buttons: 手順 4、 2の画像 2

Remove the battery cover from the device by pulling it straight out.

編集

手順5

Using the plastic opening tool remove the front and rear yellow covers.
When removing the back cover, be careful not to lose the buttons as they are not connected.

編集

手順6

Remove the two 3.1 mm Phillips #0 screws.

編集

手順7

Pull the two halves apart.
Be careful not to lose any components on the inside.

編集

手順8

Realign the buttons with the button terminals.
Red terminal to red button.
Orange terminal to orange button.
Yellow terminal to yellow button.

編集

手順9 Etekcity Lasergrip 1080 Trigger Replacement

Etekcity Lasergrip 1080 Trigger Replacement, Etekcity Lasergrip 1080 Trigger Replacement: 手順 9、 2の画像 1

Etekcity Lasergrip 1080 Trigger Replacement, Etekcity Lasergrip 1080 Trigger Replacement: 手順 9、 2の画像 2

Carefully pull the trigger out.
The trigger is spring loaded, so be careful that you do not lose the spring as you pull the trigger out.
To put the trigger back in, align the peg with the hole in the handle and align the shaft with the button terminal.