メインコンテンツにスキップ

Epson Stylus NX230 Scanner Motor Replacement

必要な工具と部品

  1. Epson Stylus NX230 Scanner Motor Replacement, Scanner Motor: 手順 1、 1の画像 1
    • Check that the printer is unplugged to prevent shock.

    • Turn the printer so the front buttons are facing away from you.

  2. Epson Stylus NX230 Scanner Motor Replacement: 手順 2、 1の画像 1
    • Locate the 3mm Phillips #0 screw in the top left corner of the printer.

    • Remove the screw using a Phillips head screwdriver.

    • Store the screw in a safe place where you can access them later.

  3. Epson Stylus NX230 Scanner Motor Replacement: 手順 3、 1の画像 1
    • Flip the top of the printer up so that you can see the inside of the printer.

    • There is a white ribbon cable in the right top corner of the printer.

    • Make sure that the white ribbon does not come detached from the right side of the printer.

  4. Epson Stylus NX230 Scanner Motor Replacement: 手順 4、 1の画像 1
    • Lay the scanner face up so you can access the under side, and place something, such as a piece of Styrofoam, underneath of it so that the white tape does not become detached.

    • Locate the four 3mm Phillips #2 screws along the edge, and remove all of them.

    • Store the screws in a safe place where you can access them later.

  5. Epson Stylus NX230 Scanner Motor Replacement: 手順 5、 2の画像 1 Epson Stylus NX230 Scanner Motor Replacement: 手順 5、 2の画像 2
    • Locate the seam on between outer shell of the printer and the inside of the printer.

    • Starting from the top of the printer, use the plastic opening tool to slowly pry the scanner apart along the seam.

  6. Epson Stylus NX230 Scanner Motor Replacement: 手順 6、 2の画像 1 Epson Stylus NX230 Scanner Motor Replacement: 手順 6、 2の画像 2
    • Detach the bottom of the scanner.

    • Flip the bottom of the scanner over so that it rests on top of the printer.

    • This gives you access to the motor.

  7. Epson Stylus NX230 Scanner Motor Replacement: 手順 7、 1の画像 1
    • Gently lift the scanner bar in order to remove it from the scanner.

    • Detach the white ribbon cable from the scanner bar.

  8. Epson Stylus NX230 Scanner Motor Replacement: 手順 8、 1の画像 1
    • Remove the two 3mm Phillips #2 screws on the underside of the scanner bar attached to the silver motor.

    • Remove the motor from the scanner bar by gently pulling the motor upwards.

終わりに

To reassemble your device, follow these instructions in reverse order.

作成者

4人の作成者と共同で作成されました。

Kimberly Pugel

メンバー登録日: 04/07/14

404 ポイント

3のガイドは作成済み

チーム

Cal Poly, Team 6-1, Forte Spring 2014 Cal Poly, Team 6-1, Forte Spring 2014人のメンバー

CPSU-FORTE-S14S6G1

4 メンバー

10のガイドは作成済み

0 件のコメント

コメントを追加

統計データ:

過去 24時間: 0

過去 7 日: 1

過去 30 日: 7

今までの合計 914