Enabot EBO SE Lower Housing Replacement

はじめに

The lower housing is very important to your Enabot EBO SE since this is where the daughterboard, battery, and speaker are located. You will potentially need to replace them for your Enabot EBO SE to continue functioning correctly. We will take you step by step to replace these necessities and hopefully help you have a more pleasant experience.

必要な工具と部品

手順1 Wheel Assembly

Enabot EBO SE Lower Housing Replacement, Wheel Assembly: 手順 1、 1の画像 1

Gently turn the robot upside down.
Place the robot on a stable surface to prevent it from rolling or falling.

翻訳

手順2

Enabot EBO SE Lower Housing Replacement: 手順 2、 3の画像 3

Use a flathead 2.5 mm screwdriver to remove the 5.7 mm screw from the wheels.
A tool should have been provided in the box for this purpose.

翻訳

手順3

Pull the wheel assembly towards you so it comes straight off without resistance.
If there is resistance, make sure to apply gentle force when pulling as it can get damaged with too much force.

翻訳

手順4 Lower Housing

Enabot EBO SE Lower Housing Replacement, Lower Housing: 手順 4、 2の画像 1

Enabot EBO SE Lower Housing Replacement, Lower Housing: 手順 4、 2の画像 2

Use a Torx screwdriver to remove the four 9 mm screws from the assembly.

翻訳

手順5

Enabot EBO SE Lower Housing Replacement: 手順 5、 3の画像 3

Use your fingernail to carefully press down and eject the Micro SD Card from the back of the Enabot.
Keep the Micro SD Card in a safe spot for later.

翻訳

手順6

Place the iFixit opening tool inside the Micro SD slot.
Very carefully apply pressure to the top of the slot and pry open the casing to separate the upper and lower housing.

翻訳

手順7

Enabot EBO SE Lower Housing Replacement: 手順 7、 3の画像 3

Using the iFixit opening tool or your fingernail, place it underneath the gray tab on the lower housing.
Lift the tab up and pull out the ribbon cable to disconnect it from the lower housing.

翻訳

手順8

Enabot EBO SE Lower Housing Replacement: 手順 8、 3の画像 3

There are two black and red wire connectors attached to the upper and lower housing.
Gently use your finger nails to lift up and disconnect both wires to fully separate the upper and lower housings.

翻訳