メインコンテンツにスキップ

修理を始めるには

修理する権利

パーツ&ツール

はじめに

If your EGO battery-powered lawn mower will not start or sometimes stops while running, the connector for handle safety switch might be defective.

  1. Remove the battery
    • Remove the battery

    • Get a container to hold all the screws you will be removing. There are many!

    • Remove the 6 screws that hold the battery box in place. Use a marking pen to indicate the colors of the 3 wires connected to the battery box. (red, blue, black)

    • Disconnect the ribbon cable from the bottom of the control panel where the headlight switch and warning lamps are located.

    • Turn the mower on its side and remove the blade.

    • Remove all the screws from the bottom panel of the mower.

    • Remove the height adjustment knob

    • Remove the top cover. If it isn't coming off, check to see if you've removed all the screws.

    • Use a small clamp to push down the safety switch that detects that the top cover has been removed. The mower will not run if this switch isn't pushed.

    • Extend the mower handle to the operating position. The mower will not run if handle isn't extended. There's a micro switch in the handle latch assembly, on the side with the cable.

    • Connect the battery box. Be sure to put the correct wires on each of the 3 terminals.

    • Insert the battery. Push down hard until it clicks.

    • Start the mower with the handle switch.

    • Locate the 3-wire cable and connector on the logic board that connects to the safety switch in the handle. (See the video) Wiggle this cable to see if the motor starts or stops.

  2. Nintendo Switch 修理キット

    ゲームを再開するための、早くて簡単な修理キット

    Switch 修理キットページへ

    Nintendo Switch 修理キット

    ゲームを再開するための、早くて簡単な修理キット

    Switch 修理キットページへ
  3. Make note of the colors of the 3 wires on the connector. (It's a 3-pin Molex SPOX female connector, with  a 3.96 mm pitch.) Cut the wires close to the connector. Install a replacement connector. I used a Molex connector from a PC power supply cable in my junk collection. Cut down the connector to 3 wires.
    • Check that the replaced connector is working correctly, using the same process used in the diagnosis step.

    • Reassemble the mower.

終わりに

To reassemble your device, follow these instructions in reverse order.

2 の人々がこのガイドを完成させました。

Wayne Seltzer

メンバー登録日: 2010年11月09日

377 ポイント

3のガイドは作成済み

チーム

Boulder U-Fix-It Clinic Boulder U-Fix-It Clinic人のメンバー

Community

1 メンバー

3のガイドは作成済み

0 件のコメント

コメントを追加

統計データを表示:

過去 24時間: 27

過去 7 日: 266

過去 30 日: 910

今までの合計 2,441