Dremel 8220 Motor Replacement

作成者： Shailing Santiago (そして 5 人のその他投稿者)

コメント: 1
お気に入り: 0
完了: 2

難易度

普通

手順

所要時間

10分

はじめに

This guide will show you how to replace a defective motor. With a few steps and a some tools, you will be able to open up the device and gain access to the motor. The motor can then be easily swapped out for a new one so that it can start working again.

ツール

これらのツールを購入する

T9 Torx Screwdriver

$6.99

購入する

パーツ

パーツは指定されていません。

手順1 Motor

Locate the battery at the back of your Dremel. Firmly grasp the battery on both sides and pull. It should easily come out of the battery well.

Locate the battery at the back of your Dremel. Firmly grasp the battery on both sides and pull. It should easily come out of the battery well.

編集

手順2

Remove the ring located around the speed selector switch by pulling apart on either side. (This should require very minimal force)

Remove the ring located around the speed selector switch by pulling apart on either side. (This should require very minimal force)

編集

手順3

Remove the collar wrench by pushing the gear lock button. Continue to hold this button as you rotate the wrench counter-clockwise until it is removed.

Remove the collar wrench by pushing the gear lock button. Continue to hold this button as you rotate the wrench counter-clockwise until it is removed.

編集

手順4

Remove the metal clasp from the battery well. This piece helps hold the plastic shell of the device together. Pry it out by gently applying some force with a screwdriver.

Remove the metal clasp from the battery well. This piece helps hold the plastic shell of the device together. Pry it out by gently applying some force with a screwdriver.

編集

手順5

Remove 5 of the 10.5 mm torx screws using a t9 bit. (specific head for a screwdriver)

Now pull apart the plastic shell of the device. If you are not able to, review the previous steps as you may have missed one.

Remove 5 of the 10.5 mm torx screws using a t9 bit. (specific head for a screwdriver)
Now pull apart the plastic shell of the device. If you are not able to, review the previous steps as you may have missed one.

編集

手順6

Remove broken motor. Lift out the motor until you can see where the wires that connect to it.

Next remove the clips where the wires connect with the motor. This can be done with your fingers of a pair of pliers

Remove broken motor. Lift out the motor until you can see where the wires that connect to it.
Next remove the clips where the wires connect with the motor. This can be done with your fingers of a pair of pliers
You should then be able to reconnect a new motor and reassemble the device.