はじめに

The bottom of your Roomba can be easily removed by just removing the side brush, unscrewing four screws, and separating the plate from the device.

Place your Roomba upside-down on a hard surface.
  • Place your Roomba upside-down on a hard surface.

If all you need off is the faceplate, skip all of the screwdriver-based steps, and just remove the dirt bin(step 7) and start from step 11 at the rear.

David Forrest - 返信

While holding the side brush in place, use a Phillips #1 screwdriver to remove the 4.5mm screw from the center of the brush.
  • While holding the side brush in place, use a Phillips #1 screwdriver to remove the 4.5mm screw from the center of the brush.

コメントを追加する

  • Gently pull upwards on the brush to remove it.

コメントを追加する

  • Rotate the Roomba upside-down so the bottom is facing towards you.

コメントを追加する

  • Using a Phillips #2 screwdriver, remove the captive screws that hold the bottom plate in place.

コメントを追加する

  • Carefully lift the bottom plate.

  • The battery is only secured in place by the bottom plate, and may fall out once the bottom plate is removed.

コメントを追加する

まとめ

To reassemble your device, follow these instructions in reverse order.

Deborah Newberry

メンバー登録日: 2014年01月23日

551 ポイント

4のガイドは作成済み

チーム

Cal Poly, Team 13-14, Regan Winter 2014 Cal Poly, Team 13-14, Regan Winter 2014人のメンバー

CPSU-REGAN-W14S13G14

4 メンバー

13のガイドは作成済み

コメントを追加する

統計データを表示:

過去 24時間: 1

過去 7 日: 1

過去 30 日: 4

今までの合計 337