メインコンテンツにスキップ

修理を始めるには

修理する権利

パーツ&ツール

はじめに

This guide has been updated by iFixit staff! Read the new, official guide here.

  1. Using a 5-point pentalobe screwdriver, unscrew the 2 pentalobe on the bottom of the phone near the dock connector.
    • Using a 5-point pentalobe screwdriver, unscrew the 2 pentalobe on the bottom of the phone near the dock connector.

  2. Push the back glass towards the top of the phone.
    • Push the back glass towards the top of the phone.

  3. Using a #000 Phillips screwdriver, unscrew the 2 very small Phillips screws.
    • Using a #000 Phillips screwdriver, unscrew the 2 very small Phillips screws.

  4. Nintendo Switch 修理キット

    ゲームを再開するための、早くて簡単な修理キット

    Switch 修理キットページへ

    Nintendo Switch 修理キット

    ゲームを再開するための、早くて簡単な修理キット

    Switch 修理キットページへ
  5. Using a plastic opener tool, pry up the battery connector shield. Be careful not to lose the smaller antenna connector shield under the top  connector sheild. Using a plastic opener tool, pry up the battery connector.
    • Using a plastic opener tool, pry up the battery connector shield. Be careful not to lose the smaller antenna connector shield under the top connector sheild.

    • Using a plastic opener tool, pry up the battery connector.

  6. Pull upwards on the plastic tab. If it's the first time, you may have to use the plastic pry tool on the outside (right) edge of the battery to loosen battery first.
    • Pull upwards on the plastic tab. If it's the first time, you may have to use the plastic pry tool on the outside (right) edge of the battery to loosen battery first.

    • Then, out pops the battery.

  7. Unscrew the 4 phillips screws holding the shield covering 6 of the 8 connectors.
    • Unscrew the 4 phillips screws holding the shield covering 6 of the 8 connectors.

    • Make sure to keep track of which screws are which, they very by tenths of a millimeter.

  8. Using a plastic opening tool, pry the back camera connector from the logic board. Be careful not to lose the small square peice of plastic covering the bottom of the camera, it comes off very easily.
    • Using a plastic opening tool, pry the back camera connector from the logic board.

    • Be careful not to lose the small square peice of plastic covering the bottom of the camera, it comes off very easily.

終わりに

To reassemble your device, follow these instructions in reverse order.

4 の人々がこのガイドを完成させました。

Chandler Skinner

メンバー登録日: 2011年10月15日

3,721 ポイント

6のガイドは作成済み

0 件のコメント

コメントを追加

統計データを表示:

過去 24時間: 0

過去 7 日: 0

過去 30 日: 0

今までの合計 2,661