はじめに

This disassembly prerequisite is required to access most components in the phone, as the swivel assembly also secures the display section to its housing.

Grip the lower portion of the back of the phone and slide downwards.
  • Grip the lower portion of the back of the phone and slide downwards.

コメントを追加する

Lift battery at the rounded notch near the bottom of the phone.
  • Lift battery at the rounded notch near the bottom of the phone.

コメントを追加する

Unscrew the four Torx screws from the backplate.
  • Unscrew the four Torx screws from the backplate.

  • The backplate may begin to separate from the keypad face. Do not try to remove it yet.

  • The screws are T5 Torx screws, 5.6mm.

コメントを追加する

Swivel the phone open.
  • Swivel the phone open.

コメントを追加する

Using the Spudger, gently pry up the U-shaped grey cover below the keypad.
  • Using the Spudger, gently pry up the U-shaped grey cover below the keypad.

  • The cover is secured with adhesive tape. The gentler this is removed, the easier it will be to reassemble.

コメントを追加する

Remove the two Torx screws from below the cover.
  • Remove the two Torx screws from below the cover.

  • These are T5 Torx screws, 8.6mm.

コメントを追加する

Gently work a spudger or a fingernail between the keypad face and the backplate.
  • Gently work a spudger or a fingernail between the keypad face and the backplate.

  • The pieces are clipped together most tightly at the bottom loop section.

コメントを追加する

Separate the keypad face from the backplate. The keypad keys and the button component are both loose inside the phone, so take note of their orientation in case they become dislodged.
  • Separate the keypad face from the backplate.

  • The keypad keys and the button component are both loose inside the phone, so take note of their orientation in case they become dislodged.

  • Take note of the braided cord's state. Upon reassembly it should be returned to the same orientation.

コメントを追加する

Holding the backplate away from the swivel, remove the 4 small Phillips screws and both stamped struts from the swivel assembly. Note that only the bottom strut has a tab. The screws are Phillips, 2.9mm
  • Holding the backplate away from the swivel, remove the 4 small Phillips screws and both stamped struts from the swivel assembly.

  • Note that only the bottom strut has a tab.

  • The screws are Phillips, 2.9mm

コメントを追加する

The back housing is now disassembled, and the swivel assembly is revealed.
  • The back housing is now disassembled, and the swivel assembly is revealed.

コメントを追加する

まとめ

To reassemble your device, follow these instructions in reverse order.

Beau Blanchard

メンバー登録日: 2012年09月30日

20 ポイント

12のガイドは作成済み

チーム

University of Maine, Team 1-5, Diaz Fall 2012 University of Maine, Team 1-5, Diaz Fall 2012人のメンバー

UMAINE-DIAZ-F12S1G5

1 メンバー

12のガイドは作成済み

コメントを追加する

統計データを表示:

過去 24時間: 0

過去 7 日: 0

過去 30 日: 0

今までの合計 235