パーツ

パーツは必要ありません。

Locate the battery cover on the bottom of the camera.
  • Locate the battery cover on the bottom of the camera.

コメントを追加する

Place your thumb on the battery cover and push towards the arrow. The cover will release and pop open.
  • Place your thumb on the battery cover and push towards the arrow. The cover will release and pop open.

コメントを追加する

Remove the batteries from the camera.
  • Remove the batteries from the camera.

コメントを追加する

Unscrew and remove four (3mm) screws on the right side of the camera. This will release the front and back casings.
  • Unscrew and remove four (3mm) screws on the right side of the camera. This will release the front and back casings.

コメントを追加する

Use your nail or a flat object to pry up the edge of the front casing. Push the casing up and back.
  • Use your nail or a flat object to pry up the edge of the front casing. Push the casing up and back.

  • Repeat this step for the back casing.

コメントを追加する

Locate the black plastic strip under the screen above the white plastic strip.
  • Locate the black plastic strip under the screen above the white plastic strip.

コメントを追加する

Pull up both sides of the black piece up about a mm.
  • Pull up both sides of the black piece up about a mm.

  • The black plastic piece is not meant to come all the way off, just enough to release the screen.

  • Once the piece is lifted carefully slide the screen out of the slot.

コメントを追加する

Unscrew and remove the four (6 mm) screws on the inside casing.
  • Unscrew and remove the four (6 mm) screws on the inside casing.

コメントを追加する

Pull the inner casing off of the camera.
  • Pull the inner casing off of the camera.

コメントを追加する

Unscrew and remove the four (4mm) screws from the logic board.
  • Unscrew and remove the four (4mm) screws from the logic board.

コメントを追加する

Use a spudger to pry up all four sides of the logic board and slide it out of the camera.
  • Use a spudger to pry up all four sides of the logic board and slide it out of the camera.

コメントを追加する

Unscrew and remove the two (5mm) screws from the logic board to the far left.
  • Unscrew and remove the two (5mm) screws from the logic board to the far left.

コメントを追加する

Locate the black plastic piece behind the lens.
  • Locate the black plastic piece behind the lens.

コメントを追加する

Similar to the LCD screen, pull the black piece up about a mm and it will release the lens.
  • Similar to the LCD screen, pull the black piece up about a mm and it will release the lens.

  • The piece will not come all the way off; only enough to release the lens.

  • Once the black piece is lifted slide the ribbon out to release the lens.

コメントを追加する

まとめ

To reassemble your device, follow these instructions in reverse order.

Dani

メンバー登録日: 2010年06月24日

21 ポイント

7のガイドは作成済み

チーム

Cal Poly, Team 3-3, Johann Summer 2010 Cal Poly, Team 3-3, Johann Summer 2010人のメンバー

CPSU-JOHANN-R10S3G3

2 メンバー

7のガイドは作成済み

コメントを追加する

統計データを表示:

過去 24時間: 0

過去 7 日: 0

過去 30 日: 1

今までの合計 847