修理を始めるには

修理する権利

パーツ＆ツール

Disassembling Panasonic Lumix DMC-TZ5 Back Cover

作成者： Ben Canfield (そして 5 人のその他投稿者)
  • コメント: 1
  • お気に入り: 2
  • 完了: 4

難易度

簡単

手順

7

所要時間

5分

セクション

1

フラグ

0

はじめに

Since this is step one, you will just need to start with your camera.

ツール

これらのツールを購入する

パーツ

パーツは指定されていません。

  1. Remove the battery and memory card from the device.

    • Remove the battery and memory card from the device.

    翻訳

  2. Remove 4 screws from the right side of the camera.

    • Remove 4 screws from the right side of the camera.

    • There are two 3.4mm screws at the top.

    • There are two 2.2mm screws at the bottom.

    翻訳

  3. Remove the single 3.4mm screw on the left side of the camera.

    • Remove the single 3.4mm screw on the left side of the camera.

    翻訳

  4. Essential Electronics Toolkit

    Small Toolkit. Big Possibilities.

    Shop Toolkits

    Essential
    Electronics
    Toolkit

    Shop Toolkits

  5. Remove 5 screws from the base of the camera.

    • Remove 5 screws from the base of the camera.

    • There are two 2.2mm screws next to the battery compartment.

    • There are three 4mm screws around the tripod mount.

    翻訳

  6. Slowly slide the back cover away from the device

    • Slowly slide the back cover away from the device

    • The back casing is held in place by two ribbon cables. Do not pull the back cover too far from the camera.

    翻訳

  7. Detach both ribbon cables using a spudger. Use the tip of the spudger to lift the black clip upward, unlocking the ribbon cable.

    • Detach both ribbon cables using a spudger.

    • Use the tip of the spudger to lift the black clip upward, unlocking the ribbon cable.

    翻訳

  8. Remove the back casing from the camera.

    • Remove the back casing from the camera.

    翻訳
終わりに

To reassemble your device, follow these instructions in reverse order.

4 の人々がこのガイドを完成させました。

作成者

5他の投稿者と一緒に

Ben Canfield

メンバー登録日: 2010年10月10日

403 ポイント

3のガイドは作成済み

バッジ: 12

+9 個以上のバッジ

チーム

Cal Poly, Team 9-21, Regan Fall 2010 Cal Poly, Team 9-21, Regan Fall 2010人のメンバー

CPSU-REGAN-F10S9G21

4 メンバー

7のガイドは作成済み

コメント1件

コメントを追加

That is not a disassembly! All is shows is taking the back of the camera off. How about showing how to disassembly the camera down to its individual components and make repairs, like getting the lens to extend of fixing a sticking shutter.

JR Tan - 返信

コメントを追加

統計データを表示:

過去 24時間: 0

過去 7 日: 0

過去 30 日: 8

今までの合計 6,258