はじめに

Removing the Main Display

パーツ

パーツは必要ありません。

  1. Turn off the phone. Position the phone so that the back side is in view.
    • Turn off the phone.

    • Position the phone so that the back side is in view.

  2. Apply pressure on the cover while simultaneously sliding the cover downward.
    • Apply pressure on the cover while simultaneously sliding the cover downward.

    • Remove the back battery cover.

  3. Insert the spudger between the base of the phone and the phone battery. Position the phone so that the battery won't fall out of the phone. Carefully lift the battery out of the phone.
    • Insert the spudger between the base of the phone and the phone battery.

    • Position the phone so that the battery won't fall out of the phone.

    • Carefully lift the battery out of the phone.

    • The battery lifts out of the phone easily.

  4. Pro Tech ツールキットを含むご注文、もしくは総額 $100ドル以上のご注文については送料無料です。

    当社のショップを閲覧する
  5. Keep the phone closed.
    • Keep the phone closed.

    • Hold the phones sideways with the front cover of the phone facing up.

  6. Find the slight crease on the side that divides the display assembly in half. Slowly wedge the spudger into the crease.
    • Find the slight crease on the side that divides the display assembly in half.

    • Slowly wedge the spudger into the crease.

    • It's a little difficult to perform this step because the crease is narrow. Do not rush because you may damage the phone

  7. Run the spudger all along the crease while lifting up. Separate the front cover from the front base.
    • Run the spudger all along the crease while lifting up.

    • Separate the front cover from the front base.

  8. Remove the four 5mm screws on the metal casing using the T6 Torx screwdriver. Remove the four 5mm screws on the metal casing using the T6 Torx screwdriver.
    • Remove the four 5mm screws on the metal casing using the T6 Torx screwdriver.

  9. Using the spudger, disconnect the green display cable. Using the spudger, disconnect the green display cable.
    • Using the spudger, disconnect the green display cable.

  10. Lift the metal casing. Be careful not to pull the casing too hard because it is still attached to the phone by a wire. Remove the main display from under the metal casing.
    • Lift the metal casing.

    • Be careful not to pull the casing too hard because it is still attached to the phone by a wire.

    • Remove the main display from under the metal casing.

まとめ

To reassemble your device, follow these instructions in reverse order.

Michael Machado

メンバー登録日: 2011年01月21日

334 ポイント

3のガイドは作成済み

チーム

Cal Poly, Team 1-14, Amido Winter 2011 Cal Poly, Team 1-14, Amido Winter 2011人のメンバー

CPSU-AMIDO-W11S1G14

5 メンバー

16のガイドは作成済み

コメントを追加する

統計データを表示:

過去 24時間: 1

過去 7 日: 1

過去 30 日: 1

今までの合計 969