Skip to main content

はじめに

With this guide you can take your MM-4 from one solid brick of a speaker to four parts and a bunch of screws. This is useful if you are replacing a bad driver, or if the connector becomes damaged and you need to replace it.

  1. Turn the speaker face down, so the connector side is up. Remove the four #2 Philips screws on the back plate.
    • Turn the speaker face down, so the connector side is up.

    • Remove the four #2 Philips screws on the back plate.

  2. Remove the foam insert to expose the two spade connectors.
    • Remove the foam insert to expose the two spade connectors.

    • Carefully separate the connectors

  3. MacBook Battery 修理キット

    最低価格 $69.99

    Buy Now

    MacBook Battery 修理キット

    最低価格 $69.99

    Buy Now
  4. Turn the speaker so the grill side is up. Remove the four screws on the grill.  I had to use a t-10 Torx bit to remove them.
    • Turn the speaker so the grill side is up.

    • Remove the four screws on the grill. I had to use a t-10 Torx bit to remove them.

    • The grill is not glued on, but may require a bit of prying to remove.

  5. Remove the four silver bolts holding the speaker in place.  These bolts also have threads inset for the grill screws to fit into. This is a pretty quick and easy teardown, not too many parts in this one.  The meyer speaker's part number is ST-164.  It's a 16 Ohm driver.
    • Remove the four silver bolts holding the speaker in place. These bolts also have threads inset for the grill screws to fit into.

    • This is a pretty quick and easy teardown, not too many parts in this one. The meyer speaker's part number is ST-164. It's a 16 Ohm driver.

まとめ

To reassemble your device, follow these instructions in reverse order.

2 の人々がこのガイドを完成させました。

RoggeSound

メンバー登録日: 2010年06月05日

2,122 ポイント

1ガイドが承認済み

コメントを追加する

統計データを表示:

過去 24時間: 4

過去 7 日: 5

過去 30 日: 26

今までの合計 5,827