パーツ

パーツは必要ありません。

  1. First be sure to turn the power switch to the off position.
    • First be sure to turn the power switch to the off position.

    • Do this by turning the leftmost knob counter-clockwise as until the line points to "off."

  2. Now remove the battery.
    • Now remove the battery.

    • On the back of the device locate the battery cover.

    • Remove it by pushing down on the clip.

    • Then pull the piece of fabric until the battery comes out.

    • Use the long, skinny phillips head screwdriver to remove the 4 7/16" screws on the back of the device in the four corners.

    • Once unscrewed, do not try to take each screw out. Move to next step once all screwed have been unscrewed.

    • Now pull the back panel off and place it down as shown. Pull the panel straight up so you do not lose the screws.

    • Use a 9/16" socket to remove the nut around the headphone jack. Be careful to not lose the washer.

    • Remove the 7/16" phillips head screw.

    • Grab the headphone jack from inside the case and pull it toward the speaker until you can fully remove it from the device.

まとめ

To reassemble your device, follow these instructions in reverse order.

ある他の人がこのガイドを完成しました。

MacKinley

メンバー登録日: 2013年10月22日

651 ポイント

5のガイドは作成済み

チーム

University of Maryland, Team 1-1, Shastany Fall 2013 University of Maryland, Team 1-1, Shastany Fall 2013人のメンバー

UMD-SHASTANY-F13S1G1

3 メンバー

5のガイドは作成済み

統計データを表示:

過去 24時間: 1

過去 7 日: 4

過去 30 日: 17

今までの合計 1,075