メインコンテンツにスキップ

Disassembling Honeywell HY-254-TGT Plastic Assembly

必要条件のみ
この修理ガイドは、他のガイドの前提条件として使用されます。それ自体は不完全で、単独で使用されることはありません。

必要な工具と部品

  1. Disassembling Honeywell HY-254-TGT Plastic Assembly, Plastic Assembly: 手順 1、 1の画像 1
    • Remove the two 3/4" wing screws on the bottom of the fan by rotating them counter-clockwise.

  2. Disassembling Honeywell HY-254-TGT Plastic Assembly: 手順 2、 3の画像 1 Disassembling Honeywell HY-254-TGT Plastic Assembly: 手順 2、 3の画像 2 Disassembling Honeywell HY-254-TGT Plastic Assembly: 手順 2、 3の画像 3
    • Twist the fan base counter-clockwise until the pins line up as shown.

    • Pull the base straight towards you to remove it, feeding the wire through the base.

  3. Disassembling Honeywell HY-254-TGT Plastic Assembly: 手順 3、 1の画像 1
    • Remove all of the marked 1/2" Phillips #02 screws on the backside of the fan

    • Remove the two marked 3/4" Phillips #02 screws in the middle.

  4. Disassembling Honeywell HY-254-TGT Plastic Assembly: 手順 4、 3の画像 1 Disassembling Honeywell HY-254-TGT Plastic Assembly: 手順 4、 3の画像 2 Disassembling Honeywell HY-254-TGT Plastic Assembly: 手順 4、 3の画像 3
    • Use a plastic opening tool or screwdriver to pry off the back of the fan, starting from the top down.

    • Be aware of two clips inside the fan, towards the bottom third of the fan. If the back appears stuck on certain spots, push inward edges of the front casing around the problematic area.

終わりに

To reassemble your device, follow these instructions in reverse order.

2 の人々がこのガイドを完成させました。

作成者

4人の作成者と共同で作成されました。

Daniel Anderson

メンバー登録日: 10/01/15

200 ポイント

1ガイドが承認済み

チーム

Cal Poly, Team 11-6, Forte Fall 2015 Cal Poly, Team 11-6, Forte Fall 2015人のメンバー

CPSU-FORTE-F15S11G6

4 メンバー

4のガイドは作成済み

0 件のコメント

コメントを追加

統計データ:

過去 24時間: 0

過去 7 日: 0

過去 30 日: 0

今までの合計 103