メインコンテンツにスキップ

はじめに

This guide will show you how to remove the hard drive from your HP Compaq dx2000MT

  1. Turn off your computer and remove the power cable by pulling it straight out of its socket.
    • Turn off your computer and remove the power cable by pulling it straight out of its socket.

  2. Remove the two Phillips #2 screws that secure the case door to the device. Remove the two Phillips #2 screws that secure the case door to the device.
    • Remove the two Phillips #2 screws that secure the case door to the device.

  3. Remove the side case door by pushing towards the rear of the device with your hand. This may take considerable force so keep pushing! Once you slide the door back, remove it by pulling it outwards from the device.
    • Remove the side case door by pushing towards the rear of the device with your hand.

    • This may take considerable force so keep pushing!

    • Once you slide the door back, remove it by pulling it outwards from the device.

  4. Remove the side case door by pushing towards the rear of the device with your hand. Once again, this may take considerable force. Once you slide the door back, remove it by pulling it outwards from the device.
    • Remove the side case door by pushing towards the rear of the device with your hand.

    • Once again, this may take considerable force.

    • Once you slide the door back, remove it by pulling it outwards from the device.

  5. iPhoneのバッテリーキット

    Only $29.99

    Buy Now

    iPhoneのバッテリーキット

    Only $29.99

    Buy Now
  6. Remove the IDE data and power cables from the hard drive. Remove the IDE data and power cables from the hard drive. Remove the IDE data and power cables from the hard drive.
    • Remove the IDE data and power cables from the hard drive.

  7. Remove the front bezel by pulling upwards and out from below the lowest air vent. Remove the front bezel by pulling upwards and out from below the lowest air vent. Remove the front bezel by pulling upwards and out from below the lowest air vent.
    • Remove the front bezel by pulling upwards and out from below the lowest air vent.

  8. Remove the external drive faceplate by removing the two Torx T15 screws. Remove the external drive faceplate by removing the two Torx T15 screws. Remove the external drive faceplate by removing the two Torx T15 screws.
    • Remove the external drive faceplate by removing the two Torx T15 screws.

  9. Remove the following screws: Front Torx T15.
    • Remove the following screws:

    • Front Torx T15.

    • Torx T15 mounting the hard drive cage to the optical drive bay.

  10. Fully remove the hard drive cage by sliding it towards the back of the device and pulling down. Fully remove the hard drive cage by sliding it towards the back of the device and pulling down. Fully remove the hard drive cage by sliding it towards the back of the device and pulling down.
    • Fully remove the hard drive cage by sliding it towards the back of the device and pulling down.

  11. Remove the two Torx T15 screws holding this side of the hard drive in place. Remove the two Torx T15 screws holding this side of the hard drive in place. Remove the two Torx T15 screws holding this side of the hard drive in place.
    • Remove the two Torx T15 screws holding this side of the hard drive in place.

  12. Proceed to the other side of the hard drive cage. Remove the two Torx T15 screws holding this side of the hard drive in place. Remove the two Torx T15 screws holding this side of the hard drive in place.
    • Proceed to the other side of the hard drive cage.

    • Remove the two Torx T15 screws holding this side of the hard drive in place.

  13. Remove the hard drive from the hard drive cage by pulling it outward from the cage. Remove the hard drive from the hard drive cage by pulling it outward from the cage.
    • Remove the hard drive from the hard drive cage by pulling it outward from the cage.

まとめ

To reassemble your device, follow these instructions in reverse order.

3 の人々がこのガイドを完成させました。

Eva Pong

メンバー登録日: 2011年09月22日

101 ポイント

1ガイドが承認済み

チーム

Cal Poly, Team 17-16, Regan Fall 2011 Cal Poly, Team 17-16, Regan Fall 2011人のメンバー

CPSU-REGAN-F11S17G16

4 メンバー

17のガイドは作成済み

can i upgrade it to 500gb?

connor gouws - 返信

This was a bit misleading. The title of the article is “Disassembling HP Compaq dx2000MT Hard Drive.” Therefore, I expected to see someone actually disassembling a hard drive, which would have been really cool. Instead, the article shows only the removal of a hard drive from a desktop computer’s case. Perhaps the title should say “Removing HP Compaq dx2000MT Hard Drive” or at best “Disassembling HP Compaq dx2000MT Case.”

Thomas Daniel - 返信

コメントを追加する

統計データを表示:

過去 24時間: 1

過去 7 日: 170

過去 30 日: 181

今までの合計 5,711