はじめに

The LCD display can be removed and replaced if it is cracked or broken.

パーツ

パーツは必要ありません。

Remove the 2 screws(2.41mm long) on the side of the camera next to the LCD screen. Remove the 2 screws(4.08mm) on the other side.  One is located under the rubber USB flap. Remove the last screw(2.59mm) located on the bottom of the camera.
  • Remove the 2 screws(2.41mm long) on the side of the camera next to the LCD screen.

  • Remove the 2 screws(4.08mm) on the other side. One is located under the rubber USB flap.

  • Remove the last screw(2.59mm) located on the bottom of the camera.

  • Slowly pull the back cover of the camera.

コメントを追加する

Mac RAM Kits
Speed up your Mac. Max out its memory.
Mac RAM Kits
Get more memory out of your Mac.
Remove the screws(2.88mm) at the top right corner and bottom left corner of the LCD screen. Disconnect the ribbons connecting the screen to the camera. Remove the screen by lifting it off.
  • Remove the screws(2.88mm) at the top right corner and bottom left corner of the LCD screen.

  • Disconnect the ribbons connecting the screen to the camera.

  • Remove the screen by lifting it off.

コメントを追加する

まとめ

To reassemble your device, follow these instructions in reverse order.

Ben Tupas

メンバー登録日: 2011年01月13日

317 ポイント

3のガイドは作成済み

チーム

Cal Poly, Team 13-3, Forte Winter 2011 Cal Poly, Team 13-3, Forte Winter 2011人のメンバー

CPSU-FORTE-W11S13G3

5 メンバー

8のガイドは作成済み

コメント1件

Hm. "Disconnect the ribbons" resulted in a torn ribbon, and so a dead camera, I think. This also doesn't say how to take the LCD screen out of its frame. Alas.

Maelduin - 返信

コメントを追加する

統計データを表示:

過去 24時間: 0

過去 7 日: 0

過去 30 日: 0

今までの合計 2,145