はじめに

The flash device has a couple of delicate connections and should be handled with care.

パーツ

パーツは必要ありません。

Remove the 2 screws(2.41mm long) on the side of the camera next to the LCD screen.
  • Remove the 2 screws(2.41mm long) on the side of the camera next to the LCD screen.

  • Remove the 2 screws(4.08mm) on the other side. One is located under the rubber USB flap.

  • Remove the last screw(2.59mm) located on the bottom of the camera.

  • Slowly pull the back cover of the camera.

コメントを追加する

Remove the screw(2.59mm) from the bottom of the camera.
  • Remove the screw(2.59mm) from the bottom of the camera.

  • Remove the screw(4.08mm) from the menu button side of the camera.

  • The 2 screws on the other side of the camera were already removed when taking off the back cover.

コメントを追加する

  • Unplug the green (if color-blind please ask someone for assistance) and white plugs connecting the top panel to top of the logic board.

  • Dislodge the tab above the lens.

  • Dislodge the back tab.

コメントを追加する

  • Remove the screws(2.88mm) at the top right corner and bottom left corner of the LCD screen.

  • Disconnect the ribbons connecting the screen to the camera.

  • Remove the screen by lifting it off.

コメントを追加する

  • CAUTION WHEN REMOVING FLASH. BE CAREFUL,THE CAPACITOR MAY STILL HAVE A CHARGE AND COULD SHOCK YOU.

  • Remove 2 screws(1.75mm) from the back with screwdriver, disconnecting the metal guard.

  • On top of camera, unplug the ribbon by pulling on it.

  • Disconnect the white plug connected by red and black wires by pulling on it.

コメントを追加する

まとめ

To reassemble your device, follow these instructions in reverse order.

Robert Manno

メンバー登録日: 2011年01月05日

432 ポイント

4のガイドは作成済み

チーム

Cal Poly, Team 13-3, Forte Winter 2011 Cal Poly, Team 13-3, Forte Winter 2011人のメンバー

CPSU-FORTE-W11S13G3

5 メンバー

8のガイドは作成済み

コメントを追加する

統計データを表示:

過去 24時間: 0

過去 7 日: 0

過去 30 日: 14

今までの合計 2,277