はじめに

Use this guide to remove the back panel of the camera.

Place camera LCD side up and press up on the battery door.
  • Place camera LCD side up and press up on the battery door.

  • Let it swing open until you can see the battery inside.

コメントを追加する

Press down on the orange plastic.
  • Press down on the orange plastic.

  • This will gently eject the battery from its compartment.

コメントを追加する

  • Holding the edges, slide out the battery.

コメントを追加する

  • Look at the camera from the side with the lanyard and 4 screws.

    • Remove the two 3.4 mm screws on the metallic colored part.

コメントを追加する

  • Remove the 3mm screw on the top left.

    • NOTE: When reassembling, it is helpful to put the top screw back in before placing the front cover back on the camera.

  • Now remove the 5.3mm screw on the bottom.

コメントを追加する

  • Place the camera LCD side down.

  • Remove the two 5.3mm screws by the battery door.

コメントを追加する

  • Remove the four 3.4mm screws on the bottom of the camera around the tripod mount.

    • Make sure to keep these screws separate from the previous 5.3 mm screws.

コメントを追加する

  • Stand the camera back up.

  • Remove the two 3.6mm screws on the side with the A/V Out port.

コメントを追加する

  • Lift open the rubber flap covering the A/V Out port.

    • Remove the 3.4mm screw in the center.

    • During reassembly, put the A/V out rubber door on before replacing the front panel of the camera

コメントを追加する

  • Use a spudger and gently open up the front panel of the camera.

    • A thin plastic ribbon will stay connected by a brown piece to front panel of the camera.

コメントを追加する

  • There will be a brown plastic piece keeping the thin plastic ribbon in place.

  • Use the spudger to pull out the brown plastic piece attached to the orange plastic.

コメントを追加する

  • Use a pair of tweezers and remove the metal piece inside the camera.

コメントを追加する

  • Remove the battery door

    • NOTE: Putting this back on requires aligning the spring on the back of the door with the hole on the camera

コメントを追加する

  • Using a spudger, gently separate the back panel from the rest of the camera and remove it.

コメントを追加する

まとめ

To reassemble your device, follow these instructions in reverse order.

Karim

メンバー登録日: 2012年04月12日

24 ポイント

3のガイドは作成済み

チーム

Cal Poly, Team 7-34, Maness Spring 2012 Cal Poly, Team 7-34, Maness Spring 2012人のメンバー

CPSU-MANESS-S12S7G34

5 メンバー

6のガイドは作成済み

コメントを追加する

統計データを表示:

過去 24時間: 0

過去 7 日: 2

過去 30 日: 12

今までの合計 1,036